Recent content by Ivanhoe

  1. I

    One of those days ...

    Oil pressure sensor failed .... Bought new one and Disconnected some pipes to gain access ( as usual plastic clips snapped in the -10⁰c temperature) After many obscenities I had the old one off ...new one went on easy, until the threadlock took hold. Placed socket and started turning ...it...
  2. I

    Dod project question

    I think I used permatex branded assembly lube and used loads, I put that stuff all over the cam etc .. New oil pump had oil poured in so there was no bare metal inside . Disconnected Injectors and turned over to allow engine to get oil around before reconnect and fire up. Used new cheap...
  3. I

    Frozen screen fans ?

    Hair dryer warmed it up nicely....froze again later lol ...cold snap has eased thankfully.
  4. I

    Frozen screen fans ?

    Hello again...further to other issue, the cold is trying to kill my tahoe. Started on remote this morning to see if it would actually start (-40⁰c) and it did ...heard a noise from kitchen and went to check. Engine runs and is heating up but no dash fans running...I switched off and back on...
  5. I

    Rear Air Con annoyance

    Hello folks, I'm searching for ideas before I go digging. I have an annoying rear air issue, it's -35⁰c up here in the cold north. I thought I would take advantage of the rear heat to keep the family alive in the back seats. I turn it on and it's cold ...I turn to cold and it gets ice cold...
  6. I

    5.3 DoD Delete Stock Replacement Cam -- What's the Verdict

    @mikez71 No noticeable difference, runs fine. I saw it on several sites as part of a dod delete package.
  7. I

    5.3 DoD Delete Stock Replacement Cam -- What's the Verdict

    Hello, I appreciate its a few months later. I have the same engine (lmg) and used a L96 cam, removed DOD but kept vvt.
  8. I

    2017 Tahoe engine swap, advice appreciated

    My 2012 tahoe lifter failed and I changed lifters and cam. It can be done quite cheaply (compared to new motor) over a weekend, I had an old mechanic supervising and I had a rough idea what to do from youtube videos and excellent support from this forum and others. I got a texas speed kit with...
  9. I

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    300k achieved today on way home from a full set of new tyres being fitted. New tpms as old ones were starting to have issues, Went with cheap amazon ones with even cheaper on sale scanner to activate them. Truck seems to have less rolling resistance with new tyres as the instant mpg went...
  10. I

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Changed front hub assembly..went smoothly until a bolt decided it was happy staying put, it was awkward to get at with my Impact as well. Managed to get an extension on my Impact which after a few attempts managed to get it moving. Hub came off after a few gentle taps with my fine adjusting...
  11. I

    Running sweet after AFM delete

    Lucky escape with that
  12. I

    Running sweet after AFM delete

    I've been using Walmart or Costco synthetic oil and started using napa platinum filters. Oil is cheaper and meets specifications and filter is wix but cheaper somehow. At least then I know it's decent stuff on my truck
  13. I

    Running sweet after AFM delete

    Hello and thank you. Sorry I've been away so havent been on the forum lmuch. Idle is fine and I've had no issues since install. I didnt do anything to valve springs and only cleaned the head where old gasket sat and a general clean. I would strongly recommend dropping the oil pan to clean it...
  14. I

    What did you do to your NNBS GMT900 Tahoe/Yukon Today?

    Just over 5000hrs with 290000kms (180000 ish miles)
  15. I

    WHAT OIL PUMP AFTER AFM/VVT DELETE?

    I would add something like this to the oil pipe as GM only uses one bolt, just added security. Link to cradle There are other versions, it ensures it cannot come loose etc.

Forum statistics

Threads
128,790
Posts
1,805,498
Members
91,773
Latest member
wbhidalgo17
Top