-
-
FI changed all the differential, transmission, and transfer cases fluids about 10 months ago, which equated to not a lot of miles. I bet...
-
FFoggy replied to the thread 5.3 DoD Delete Stock Replacement Cam -- What's the Verdict.The camshaft in our engines is "parked" at ZERO.. The VVT can only retard the cam timing. It generally does this at higher RPM to make...
-
FFoggy replied to the thread Noise When Towing.Check your power steering fluid when cold.. There are lines on it that make it obvious. Also, Since you are 1st owner, When was the...
-
FFoggy replied to the thread Replacing torque converter - with what?.PATC in louisiana makes good converters too... The "stock" core one has a beefed up clutch and you can also order whatever stall speed...
-
FFoggy replied to the thread Low oil pressure.Change the oil filter to an AC or Wix... The fram filter (or any brand) could have an issue, be clogged with debris, or failed...
-
FFoggy replied to the thread Need front Wheel bearings (4WD) which ones are good?.Timkens are good... I'd be careful (or just NOT) buy from amazon personally. It's mostly 3rd party sellers there.. And there are LOTS...
-
FReplaced both front hub and bearings a few days ago with the Timkens, quite the difference. The RF had the most wear, the LF felt ok but...
-
FFoggy replied to the thread Post head gasket job issue.You need to relearn the throttle body/tps ... after cleaning it needs to be able to find it's "Zero"... The "open" exhaust will cause...
-
FFoggy replied to the thread How to Remove 2nd Row Bench Seating.Thanks for the input.. I'll try what was suggested !!!
-
FThey bolt to the floor. If you have the 60/40 bench then you have to remove the 60 side first, because it sits on top of the brackets...
-
FThe box mechanism is all on the bracket, you pull the second row carpet up, It's velcro'ed in front, might be good to work your fingers...
-
FFoggy replied to the thread Brand new rotors have grooves??.I always use my synthetic caliper grease on my bleeder screws.. Seems to help them seal plus I know they won't seize in place down the...
-
FFoggy replied to the thread Brand new rotors have grooves??.Too small of imperfection to worry about it... Esp not to remove and reinstall it all. Drive On !!!
-
FFoggy replied to the thread How to Remove 2nd Row Bench Seating.There is like a big "box" mechanism with the motor that tilts them... So IDK if it's even possible to remove all the stuff completely...
-
FIt's actually the "middle" seating area. I have already removed my 3rd row seating... but I need to haul some furniture a long...
-
-
Loading…
-
Loading…
