-
-
There are some suggestions in this thread... -
Blackcar replied to the thread 6.2L Lifter issue - ?.If you like vehicle and plan on keeping get with a trusted GM dealer to have repaired correctly and with GM parts if you are...
-
Blackcar reacted to West 1's post in the thread Is This Camshaft Reusable? Or Too Pitted? with
Like.
For that one bolt, I believe I pulled the bracket off that covers the bolt. The picture points out your issue glad you got it whipped... -
Right, I meant without the alignment tool, the cover can move side to side and have the seal sitting offset left or right. And yes...
-
Good time to replace it. Although mine was still holding pressure, it was getting flattened and I had it changed when the pan gasket was...
-
Blackcar replied to the thread Is This Camshaft Reusable? Or Too Pitted?.If you have gm dealer in your town I would go there they will have one you need.
-
Blackcar reacted to West 1's post in the thread Is This Camshaft Reusable? Or Too Pitted? with Like.
If this is all new to you there are a few things to be aware of. Torquing the NEW head bolts has several steps. I found the easiest...
-
Blackcar replied to the thread 07 transmission overfilled?.Looks to need more fluid to bring up full hot.
-
Engine running. Warmed Up. Level. Then Check trans fluid while running in PARK
-
Blackcar replied to the thread Is This Camshaft Reusable? Or Too Pitted?.After looking at the lifter I would replace cam but doing that all lifters should be replaced then after that you have to wonder about...
-
Blackcar replied to the thread Is This Camshaft Reusable? Or Too Pitted?.Got picture of roller lifter that came out of that position.
-
Finally in the driveway and half waxed. The dealership I bought it at put a new hood on it, painted it and also fixed and painted a...
-
Blackcar replied to the thread Do these come off easy?.I have used these plastic razor blades in link on the double face tape before and with goo gone worked fine. Then used eraser wheel on...
-
Blackcar replied to the thread Exhaust manifold paint.I have use this in link before...
-
Blackcar replied to the thread Plastic Engine Cover.Drill a 10-32 tap drill into side of post until you see brass shavings coming out then tap and install 10-32 set screw in it to stop...
-
-
Loading…
-
Loading…
