-
-
Thank you! -
AmunRoo replied to the thread Post head gasket job issue.Cleaned them with oven cleaner, front and back. Used a 2k° engine primer. Used regular DupliColor paint and clear coat.. 5 coats of the...
-
AmunRoo replied to the thread Post head gasket job issue.I also cleaned the intake manifold, throttle body and replaced the oil pressure switch. I cleaned each piston individually with oven...
-
AmunRoo replied to the thread Post head gasket job issue.
-
-
AmunRoo replied to the thread Post head gasket job issue.
-
-
So as I posted in an earlier thread, I tore down the top end of the motor to replace a bad lifter that was squealing. So the issue was...
-
AmunRoo replied to the thread Wiring harness help needed.I appreciate you guys a lot more than you know!
-
AllData interactive wiring diagram.
-
G102, lower left side of the engine.
-
All right, I need some help trying to pinpoint the path for a ground wire from the bank to coil harness. This is for the connector on...
-
AmunRoo replied to the thread Need some Advice on Engine tear down.Here's the update. I started everything Friday evening and this is where I'm at. Pulled off heads and found that valves are perfect...
-
I'm tearing the engine down to the block. I wanted to know if there's anything worth replacing while I have the heads off. I'm currently...
-
AmunRoo replied to the thread Is there such a thing as front shocks for a Z55 Denali that aren't going to cost me all the gold in FT. Knox?.Hey B-train, I am in position where i'm being offered a set of 2019 tahoe complete front strut assemblies. I would be placing them in my...
-
-
Loading…
-
Loading…
