-
-
07 Yukon Denali w/stock 6.2L L92 w/195k corrosion free miles. No DIC or CEL. It runs great. BUT the fuel gauge is all over the place... -
donjetman reacted to YukonDK's post in the thread Yet another Yukon with engine tick and low oil pressure with
Like.
Thanks! I plan to participate and share the knowledge that I’ll obtain owning this vehicle. I do appreciate all the input that I haven... -
donjetman reacted to ilikemikes's post in the thread Fuel Back Flow/Where Would You Start? - SOLVED with Like.
Solved! Dropped the tank (less than a 1/4 tank is key and easy) with a couple of jacks, one in front and one in back. Disconnect all the...
-
Ordered some new parts from BTR: valve springs, valve seals, crank bolt, lifter trays. Basically enough to get over the $200 threshold...
-
donjetman reacted to mikez71's post in the thread Ready to pull trigger on Derale trans cooler - need advice with Like.
I went with replacement lines so I wouldn't have to mess with hose clamps. Also figured the original hoses have some mileage on them...
-
donjetman reacted to Geotrash's post in the thread Ready to pull trigger on Derale trans cooler - need advice with Like.
A wise choice, I think. The good thing about the factory lines is that there aren't any places where you'll need to use clamps, which...
-
donjetman reacted to Alessandrolomb's post in the thread Accessory Drive Belt Maintenance? with Like.
Rubber belts wear out as they get older, thanks to heat and all sorts of environmental stuff. So even if your belt hasn't hit the...
-
donjetman reacted to TaboltB2015's post in the thread 14 LTZ Shutter/shake/ vibration under light throttle with Wow.
I got under it and was touching anything they would have taken off and the rear clamp on the exhaust was put on but was not tightened...
-
donjetman reacted to Geotrash's post in the thread 2007 Yukon. Lost 1st and reverse gears in transmission. Replacement options? with Like.
The '07 has an early version of the 6L80 before it was in the field long enough for weaknesses in the design or manufacturing process to...
-
donjetman reacted to HardHead's post in the thread BW4485 (NR3) awd Transfer Case Rebuild? with Like.
Folks, there are some things they don't show on YouTube. I found that the output pilot bushing was terribly loose and full of gunk. It...
-
donjetman reacted to Fless's post in the thread Engine knock and don’t know what it could be with Like.
Don't mind me, I'm just busting your chops 'cause I'm a detail nerd. One up would be 10 thou.
-
donjetman reacted to Foggy's post in the thread Ready to pull trigger on Derale trans cooler - need advice with Like.
Just for more info.. I did not open up my lower bumper/grill for my derale with the fan. I figured I would IF Needed.. but haven't...
-
donjetman reacted to Geotrash's post in the thread Ready to pull trigger on Derale trans cooler - need advice with Like.
Thanks for that. It’s worth noting that my experiments have been to handle towing at the limits in hot weather in the mountains, which...
-
only about 60% of gm parts are sourced from us, canada, mexico, leaving around 40% sourced globally with china being a significant...
-
donjetman reacted to jonawhie61989's post in the thread Engine knock and don’t know what it could be with Like.
0.020 might be what he meant I’m not in tune with machining but he said I would have to go up one piston size from standard
-
-
Loading…
-
Loading…
