Rear Windows

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

TogaPC

Full Access Member
Joined
Mar 17, 2010
Posts
135
Reaction score
11
Location
Austin, TX
When I got my Tahoe a few months ago, the rear windows would not roll down. I figured it was just a fuse but I can not figure it out. The window lock out is not on and the two front windows roll up and down. I can hear a click in the doors when I push the button but the windows don't budge at all.

Any ideas?
 

NovaRacer

Member
Joined
Dec 17, 2009
Posts
37
Reaction score
1
Location
North Carolina
When I got my Tahoe a few months ago, the rear windows would not roll down. I figured it was just a fuse but I can not figure it out. The window lock out is not on and the two front windows roll up and down. I can hear a click in the doors when I push the button but the windows don't budge at all.

Any ideas?

When you say window lock is not on, you mean the window lock on the drivers' window switch, or the child-lock on the side of each rear door?

Did you check the fuses in the panel on the side of the dash @ the drivers door?

WB
 

iwaslowr

ɹǝqɯǝɯ ɹoıuǝs
Joined
May 4, 2009
Posts
1,640
Reaction score
33
Location
Austin, Tx.
Perhaps the lockout switch is faulty and is stuck in the locked position? Or maybe you have faulty motors/regulators (or issue with wiring between the switch)? Strange that both have failed though... that's what leads me to believe it is the lock out switch. :shrug:
 

jomulk56

Resident Lurker
Joined
May 1, 2009
Posts
1,237
Reaction score
11
Location
IN
Perhaps the lockout switch is faulty and is stuck in the locked position? Or maybe you have faulty motors/regulators (or issue with wiring between the switch)? Strange that both have failed though... that's what leads me to believe it is the lock out switch. :shrug:

I agree completely with that. I'd check the switch first, and then the regulators. A multimeter is your friend.
 
OP
OP
TogaPC

TogaPC

Full Access Member
Joined
Mar 17, 2010
Posts
135
Reaction score
11
Location
Austin, TX
No I didn't mean the child safety locks. They are off. Doesn't the lockout switch also lock out the front passenger side window? If so then it's not the switch but I'll verify that in later today. I don't know anything about power windows but I have heard that the regulators are a fairly common failure point on them. The hoe has over 200,000 miles on it and is 10 years old so I expect some parts to fail. I just need to know what parts to replace and I don't have the money to take it to a shop...at least not for something as trivial as this.

Any suggestions are greatly appreciated.
 

OR VietVet

GMT800 2005 Tahoe Z71
Navy Supporting Member
Joined
Oct 8, 2014
Posts
23,701
Reaction score
44,116
Location
Willamette Valley
There is another thread at the Tahoe Forum about this. Did both rear windows stop working at the same time? If neither will go up or down and if neither will work from the master switch at the driver's door then suspect the master switch because both rear switches work thru the master switch. OR both rear regulators-(most likely)-are bad and went bad at different times and were not replaced as they went bad. OR check the wiring harness in the door jam for broken wires.
 

notinparadise

TYF Newbie
Joined
Jan 27, 2015
Posts
8
Reaction score
0
Location
Hampton VA
There is another thread at the Tahoe Forum about this. Did both rear windows stop working at the same time? If neither will go up or down and if neither will work from the master switch at the driver's door then suspect the master switch because both rear switches work thru the master switch. OR both rear regulators-(most likely)-are bad and went bad at different times and were not replaced as they went bad. OR check the wiring harness in the door jam for broken wires.

I just think both rear windows going out at the exact time is impossible. I am going to check my wiring I installed a overhead DVD player and tapped into the power window 12V feed in the pillar. I am think that is my issue. I will investigate this weekend and post an update.
 

notinparadise

TYF Newbie
Joined
Jan 27, 2015
Posts
8
Reaction score
0
Location
Hampton VA
Just pulled the pillar panel and checked for power the 12v feed to both rear windows have power (my wiring is good). Nothing from the switch. I am leaning towards the master switch on the drivers door, But why would it prevent only the the two rears windows from working?! The two front windows work perfectly? Any suggestions would be great.
 

SLCHOE

ASE Master Certified + (L1)
Joined
Nov 28, 2013
Posts
807
Reaction score
54
Location
Midvale, Utah
Master switch has failed most likely. The lockout switch would disable all 3 other windows. The fact that the front passenger window still works and both rears quit working at the same time points me at the master switch. There are tests you can do with jumper wires/power probe but that's up to you. The switches fail often due to the driver being a smoker and on rainy days leaving his window down to smoke. The rain gets in the master switch and slowly corrodes the internal contacts.
 

notinparadise

TYF Newbie
Joined
Jan 27, 2015
Posts
8
Reaction score
0
Location
Hampton VA
Master switch has failed most likely. The lockout switch would disable all 3 other windows. The fact that the front passenger window still works and both rears quit working at the same time points me at the master switch. There are tests you can do with jumper wires/power probe but that's up to you. The switches fail often due to the driver being a smoker and on rainy days leaving his window down to smoke. The rain gets in the master switch and slowly corrodes the internal contacts.

The master switch is the main switch on the drivers side front door? Would everything work on the switch besides the rear windows? I am at a loss. How do I test the switch? I don't like to buy parts unless I know the issue, but Im not sure what else it could be?
 

notinparadise

TYF Newbie
Joined
Jan 27, 2015
Posts
8
Reaction score
0
Location
Hampton VA
Okay, I took both rear door panels off and smacked the motors with a hammer a few times and BAM they work. The previous owner told me he did not have anyone in the back seat for the last 10 years. I read somewhere on a forum the motors will not release after sitting that long (IDK something about copper or windings?!). Everything is back on track and working as new!! Simple fix a flathead, 9/32 nut driver and a hammer...
 

Forum statistics

Threads
137,712
Posts
1,990,209
Members
102,704
Latest member
Ralph Turner

Latest posts

Back
Top