I was interested in ordering the switchback turn signals for my 04 Denali. It says that I would need/require LED Load Resistors. What are these and how do I install them also where do they go. Basically what is the deal with this. I am really interested in these as well as the DRL and the reverse lights as well. Thanks bro.
Question re: switchback turn signals
- Thread starter usmc1833
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
madrrio@hidguy
Member
a resistor is used so that it does not hyper flash (since leds require less current, it can go through the cycle faster causing it to hyper blink) like a ricer hahahah kidding.
the way this is hooked up is normally between the blinker and the ground, here are a few examples that i hope help, theres really only 2 choices, green to black, or green to... the other black, so figuring it out isnt too bad.
if you have any questions feel free to call us at 6194277116
the way this is hooked up is normally between the blinker and the ground, here are a few examples that i hope help, theres really only 2 choices, green to black, or green to... the other black, so figuring it out isnt too bad.
if you have any questions feel free to call us at 6194277116
