Puddle light lens part number?

[Danzigman]

My passenger side puddle lens was broken by the previous owner. It will not stay in place because the tabs are broken. Does anyone know the part number?

 

[JRich305]

I want to replace my puddle light bulb but i was afraid of breakIng those tabs. Anyone know how to take the lens out without breaking those tabs?

 

[aldrichg9]

I have the same problem on my drivers side. Was broken by PO
Just been to lazy too go to the dealer and get one.

 

[JRich305]

So no1 has a definite answer to how to take these out and replace the bulb?

 

[Mr.Jack]

From what year were these trucks made with puddle lights?

 

[JRich305]

i have a 2003 tahoe. i have seen them on years as low as 2001.

 

[Mr.Jack]

i have a 2003 tahoe. i have seen them on years as low as 2001.

Not standard though?

 

[Danzigman]

Part number anyone?

 

[Marc_Rez]

Dumb question, is this the light on the running board?

 

[Danzigman]

The light on the bottom of the mirrors.

 

[Danzigman]

I finally found it. posting it here for reference.

88980307 outside rear view mirror courtesy lamp (driver or passenger side)

 

[Forrest39]

I finally found it. posting it here for reference.

88980307 outside rear view mirror courtesy lamp (driver or passenger side)

I was looking for this part number too. Thanks for posting!

 

[Michael419]

My passenger side puddle lens was broken by the previous owner. It will not stay in place because the tabs are broken. Does anyone know the part number?

The part # is 88980307 fits 2000-2006 Tahoe.

 

[Danzigman]

Thanks!

 

[cmc76]

those things are $100 a piece? what am I missing?

 

[ezdaar]

Take the time to sand off then polish the texture on the lens. If done correctly, it will be crystal clear.
Even go as far as tape over the lens and use some "chrome" paint from auto store to paint the exterior section that fits inside the mirror assembly.

This will put a mirror like reflective surface inside the lamp assembly and force all the available light out through the lens.
This increases the total lumen output significantly.

 

[cmc76]

my issue is more the tabs not holding the assembly in firmly. I think I will hot glue or silicone them tight before shelling out 100 a piece.

 

[ezdaar]

use a lighter to heat up the tabs and bend them out some.
hold them until the tabs cool completely.


Dont get crazy with it.
If you break them, I have Plenty, as I mod and sell them.

 

[brian.roberts.1293]

use a lighter to heat up the tabs and bend them out some.
hold them until the tabs cool completely.


Dont get crazy with it.
If you break them, I have Plenty, as I mod and sell them.

How much do you charge. And what exactly do you mod?

04 green Z71 Suburban lightly modding it and eying all the tips on this site

 

[05Single]

Yea would like to know details on this too
ezdarr