Led license plate light issues

[fatboyracing]

So one side of my license plate light flashes on and off sometimes it did not do this with standard bulbs or I did not notice

Any ideas I swapped bulbs left to right and the problem stays on the drivers side so I don't think it is the bulb

 

[NathanJax]

Loose wire on the connector?

 

[13yukon]

So one side of my license plate light flashes on and off sometimes it did not do this with standard bulbs or I did not notice

Any ideas I swapped bulbs left to right and the problem stays on the drivers side so I don't think it is the bulb

Possible cheap/defective. LED. I had the same issue until I switched to Sylvania Zevos

 

[01Konvict]

cheap LEDs and is on the way to dying

 

[fatboyracing]

Possible cheap/defective. LED. I had the same issue until I switched to Sylvania Zevos

same issue at the license plate lights?

 

[fatboyracing]

cheap LEDs and is on the way to dying

they are v-led I thought they where a good brand but what is weird is when I move the light to the other side the light works the problem just stays on the drivers side

 

[fatboyracing]

Loose wire on the connector?

How could I check this, do I just replace it to test?

 

[01Konvict]

Take a volt meter to the wires and see if its fluctuating then fix loose wires on back side or trace them to source

 

[13yukon]

same issue at the license plate lights?

Yes plate lights.

 

[fatboyracing]

Yes plate lights.

Thanks

 

[NathanJax]

Take a volt meter to the wires and see if its fluctuating then fix loose wires on back side or trace them to source

this

Does the power/ground stay the same or is it going in/out?

 

[Vanquish Auto]

So one side of my license plate light flashes on and off sometimes it did not do this with standard bulbs or I did not notice

Any ideas I swapped bulbs left to right and the problem stays on the drivers side so I don't think it is the bulb

It is because you do not have the right bulbs.

 

[Dillon2222]

I would def. check the wiring. On my Yukon i had found that both bulbs were not working. After testing with a test light and a DMM i had found that i was getting power to the sockets but they were not coming on. After looking at the wiring ( taking the wire cover and electrical tape off) i had found that the ground wire had a bad splice coming from the one ground wire from the harness connector to the two going to the bulb sockets.

 

[05Single]

Try error free bulbs