blizz
Full Access Member
according to the specs you can cure it with the heat from the engine...i'd say a short road trip would be good.
Gettin' some headers tomorrow
- Thread starter destroyer1362
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
destroyer1362
A work in progress
It's a toss-up between Eastwood and this rustoleum stuff: http://www.grainger.com/Grainger/items/4YKZ9?Pid=search Heres an article with their grill paint on an exhaust system: http://www.triumphrat.net/twins-technical-talk/112355-new-rustoleum-bbq-paint-on.html I can only imagine that the stuff made for the exhaust will be even better.
.. And I know Autozone carries it.
.. And I know Autozone carries it.
OP
OP
destroyer1362
A work in progress
So I went with the rustoleum after hearing some testimonials and seeing how well it holds up.
I was looking at the hardware for the install and I have a question; what is a heat stove? and where do I install it. Pics would be helpful.
---------- Post added at 02:18 AM ---------- Previous post was at 02:16 AM ----------
Write-up coming soon.. Once I finish the install.
I was looking at the hardware for the install and I have a question; what is a heat stove? and where do I install it. Pics would be helpful.
---------- Post added at 02:18 AM ---------- Previous post was at 02:16 AM ----------
Write-up coming soon.. Once I finish the install.
Assuming you've got a vortec motor, you don't have/need the heat stove. Basically, it's a short pipe that runs from one of the primaries to the intake to warm the incoming air. IIRC, it doesn't feed any exhaust into the intake - just acts to transfer heat.
OP
OP
destroyer1362
A work in progress
Thanks for the info ^ .
So they're installed, made a big difference
I should have the write-up up later tonight.. probably just for the install though. I was going to have another up for prep and paint but I ran into a problem (I followed the directions for painting and about 75% of the paint flaked off
)
So they're installed, made a big difference
I should have the write-up up later tonight.. probably just for the install though. I was going to have another up for prep and paint but I ran into a problem (I followed the directions for painting and about 75% of the paint flaked off
)AtomicHoe094
Atomichoe094
shoulda sent em to me 
haha
haha
kickitandholdit
Full Access Member
copper gaskets
OP
OP
destroyer1362
A work in progress
shoulda sent em to me
Yeah I know
but with my luck they would have gotten lost in the mail or something lol
blizz
Full Access Member
so when you say big difference, explain. where do you feel it?
OP
OP
destroyer1362
A work in progress
Right around 3 grand it just pulls harder, and when going to pass some one. All around it seems more responsive. Under normal acceleration there is a noticeable difference in how much less I have to press the petal to get the same acceleration.
