PopoPackage2011
Member
- Joined
- Oct 29, 2023
- Posts
- 51
- Reaction score
- 52
Hey guys its been awhile, please note-----PICS TO COME!!!!!!
What would I be able to ask for/actually get for this rig?
It starts, runs, drives, shifts and stops good.
Theres always a catch.
2011 PPV 2wd 150K miles, shes not quite a looker..... 5.3L 6L80.... K&N setup whoopdy do.
I fell on hard times and had to take the hoe off the road.
Its been my reliable daily driver for about 2.5 years now. Bought it from a guy on Long Island who got it at auction. Got it with nice looking oil and have done the changes myself with Mobil1 synthetic. I traced the truck back to Gwinnett County, GA Police Dept. it was a k-9 truck. Still has paint shadows of the decals on the roof.
No rear seats (2nd nor 3rd row) no center console. Ugly yellowed headlights. Windshield has a small crack on drivers side.
Typical GMT900 problems like the front blower fan wiring needs to be played with time to time, rear window switches are beat. Hood latch cable and tailgate latch need replacing.
Could use a tranny fluid flush and filters, a good diff fluid change too. Shifts fine though. I also replaced the radiator, hoses and water pump a couple months after getting it.
Also has power steering issues (I did the pump and lines, but its still pissing from the line connect, or worse case scenario-the rack. Ive just been topping it off as needed after I noticed it still slowly leaks after I installed a new GM pump.) It steers fine, no play.
If that wasn't bad enough, well here comes the ugly.....heh
It took a hit where the driver door meets the front fender.****I have kept it in the garage since***** I'm considering doing that work myself. The driver door doesn't seal on the top, but the door still latches closed.
I'm worried it may be a parts vehicle, and possibly don't want to mess with the fender and door, if the hinges got moved a little bit in the accident, the new door obviously wont close right and id be f***ing myself. I'm not a body guy, but have more than basic mechanical knowledge/skills.
What do you guys think I should ask for this hog? Serious answers only, hah. Im in lower New York. Any advice would be greatly appreciated. Thanks
What would I be able to ask for/actually get for this rig?
It starts, runs, drives, shifts and stops good.
Theres always a catch.
2011 PPV 2wd 150K miles, shes not quite a looker..... 5.3L 6L80.... K&N setup whoopdy do.
I fell on hard times and had to take the hoe off the road.
Its been my reliable daily driver for about 2.5 years now. Bought it from a guy on Long Island who got it at auction. Got it with nice looking oil and have done the changes myself with Mobil1 synthetic. I traced the truck back to Gwinnett County, GA Police Dept. it was a k-9 truck. Still has paint shadows of the decals on the roof.
No rear seats (2nd nor 3rd row) no center console. Ugly yellowed headlights. Windshield has a small crack on drivers side.
Typical GMT900 problems like the front blower fan wiring needs to be played with time to time, rear window switches are beat. Hood latch cable and tailgate latch need replacing.
Could use a tranny fluid flush and filters, a good diff fluid change too. Shifts fine though. I also replaced the radiator, hoses and water pump a couple months after getting it.
Also has power steering issues (I did the pump and lines, but its still pissing from the line connect, or worse case scenario-the rack. Ive just been topping it off as needed after I noticed it still slowly leaks after I installed a new GM pump.) It steers fine, no play.
If that wasn't bad enough, well here comes the ugly.....heh
It took a hit where the driver door meets the front fender.****I have kept it in the garage since***** I'm considering doing that work myself. The driver door doesn't seal on the top, but the door still latches closed.
I'm worried it may be a parts vehicle, and possibly don't want to mess with the fender and door, if the hinges got moved a little bit in the accident, the new door obviously wont close right and id be f***ing myself. I'm not a body guy, but have more than basic mechanical knowledge/skills.
What do you guys think I should ask for this hog? Serious answers only, hah. Im in lower New York. Any advice would be greatly appreciated. Thanks
