acainindy
Full Access Member
I just got a DDM HID 35W 6000K kit for my 2008 Tahoe LTZ. Do I need the relay wiring harness or not for them to run right? What would the advantages be if I had the harness?
DDM HID wiring question
- Thread starter acainindy
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
mtbennett24
Full Access Member
- Joined
- Feb 1, 2010
- Posts
- 117
- Reaction score
- 0
My Ballasts would not even fire up until I used the harness.
yukon07Artic
Full Access Member
this has been covered numerous times. YOU MUST USE THE RELAY!
Conor
"Bob's your Uncle"
Dont be intimidated about installing the relay harness. It is a very fast and easy job, the harness and relay run in tandom with each other. The hardest part is finding a place to hide the extra wire. And it is only $15
UofMZ71
Full Access Member
- Joined
- Jun 10, 2009
- Posts
- 657
- Reaction score
- 1
get the harness. its not too hard to hide, but since the tahoes are big and the harness is not very long, go to radio shack and get some two color 18 gauge wire (i believe that the right size), crimps, zip ties, and that plastic tubing stuff (to hide it). make sure to mark the correct wires when cutting.
Conor
"Bob's your Uncle"
Carefull with cutting the wires. I was kind of joking when I said that hiding the extra wires was the hardest part. I would not recommend cutting the harness.
UofMZ71
Full Access Member
- Joined
- Jun 10, 2009
- Posts
- 657
- Reaction score
- 1
how did you run the harness? i found (even tho i had a hard time installing
haha) that cutting it and running it by the firewall looked the best. it wouldnt fit otherwise
Conor
"Bob's your Uncle"
I hid a small coil of wire in behind my CAI box
UofMZ71
Full Access Member
- Joined
- Jun 10, 2009
- Posts
- 657
- Reaction score
- 1
but what about the wires to the driver light? you run it in front of the radiator?
