bowtiefreak
No Quarter
go 4.88
cheap front level
- Thread starter the big blue bus
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
the big blue bus
Full Access Member
seems like the smarter way.... thanks sorry for all the dumb questions.
on a side note got some truck bars from a guy. they are thicker than the 4dr tahoe bars. hopefully they work better than the saggy ones i got now. need to get em in and trim some a little and get it aligned. the guy i got them from had a bad ass 89 chevy with sas on 11 inches of lift and 38s. it had plenty of room still.
on a side note got some truck bars from a guy. they are thicker than the 4dr tahoe bars. hopefully they work better than the saggy ones i got now. need to get em in and trim some a little and get it aligned. the guy i got them from had a bad ass 89 chevy with sas on 11 inches of lift and 38s. it had plenty of room still.
Freedom Motorsports
Full Access Member
- Joined
- Jul 16, 2011
- Posts
- 933
- Reaction score
- 20
That's lookin good...
OP
OP
the big blue bus
Full Access Member
thanks man
bowtiefreak
No Quarter
there's no dumb questions, better to ask and ask and ask before doing something wrong
OP
OP
the big blue bus
Full Access Member
putting the truck bars in this weekend. will see if they help raise it some more to level with 2inch block
bowtiefreak
No Quarter
post some pics.
OP
OP
the big blue bus
Full Access Member
of the bars? or them installed?
bowtiefreak
No Quarter
new stance of the truck after the install. Measure the fender before and after....
OP
OP
the big blue bus
Full Access Member
okay will do. will post back with the results
OP
OP
the big blue bus
Full Access Member
got them on today... biggest pain in ass lol. didnt knw they were labled left and right so got it on wrong and tried to load em and ended up messin up my torsion bar tool. had to use a c clamp. had to take trans crossmember out and the t bar one to get the bars in and out. had to use head to break em loose and a lot of hammers. one of my boots got burnt so greeese is everywhere need a new one now and need to go get it aligned . i cranked em too much when we did em so it rides like a tank. it bounces so much. going to lower it some tomorrow. got over an inch of lift before. fronts higher now. going to lower to level and improve ride i hope. not something i like to do again lol but truck bars do work on tahoes! they are thicker and longer but no issuses. when we did my buddys 00 1500 the bars literaly slid out.. mine not so much lol. will get some pictures tomorrow after i get the height all dailed it. not bad for 20 bucks but too from 11 till 5 almost because we calld everywhere trying to find a new torsion bar tool but ended up having to use a large c clamp to get my truck out of their shop
Similar threads
