3 inch body lift and 2-2.5 leveling kit

[Tanlegged_juliet]

I have a 2011 Ltz Tahoe with new 20 in rock stars can I put a 3 in body lift with the 2-2.5 front leveling strut can fit 33x12.50 nitto grapplers with out rubbing ?

 

[yates ™]

Why not just do a full suspension lift?

 

[Tanlegged_juliet]

The 3in body and level kit together is only $560 plus doesn't void any warranty

 

[08z71tahoe]

unless u plan in installing it, the install will cost over 1k... body lifts suck...

 

[fiatdale]

Body lifts arent too bad if you have the right tools. All thats really needed is a couple jacks, a few blocks of wood, and a few sockets. Ive done them with no power tools in as little as 7 hours (on a rusty older vehicle) and less than 4 with air tools.

I dont know a firm answer to your question, but I would think it should clear.

 

[Tanlegged_juliet]

Have a shop with lift and all the power tools I need install is not an issue

 

[wbreaux]

I have a 3inch body and 2.5" ccm level and I clear 34.8 with almost no rubbing

 

[cjweb11]

wbreaux, I would like to see a pic or 2 of that setup.
Thanks

 

[wbreaux]

here's the link to the thread

http://www.tahoeyukonforum.com/forum/showthread.php?t=48022

 

[Zed 71]

I have a 2011 Ltz Tahoe with new 20 in rock stars can I put a 3 in body lift with the 2-2.5 front leveling strut can fit 33x12.50 nitto grapplers with out rubbing ?

12.5" wide tire is 317.5 mm. I don't think I have seen that wide a tire on an NNBS yet with a level kit. Wonder if that would clear the UCAs?

I would look like a beast if you can pull if off. Post pics!

I have a 3inch body and 2.5" ccm level and I clear 34.8 with almost no rubbing

What width and back spacing/offset are you running?

 

[wbreaux]

12.5" wide tire is 317.5 mm. I don't think I have seen that wide a tire on an NNBS yet with a level kit. Wonder if that would clear the UCAs?

I would look like a beast if you can pull if off. Post pics!



What width and back spacing/offset are you running?

I'm running stock 20s and 34.5 x11.5. I have a friend with a leveled silverado on 12.5s and he rubs a little but not too bad. Not sure on how different the wheel wells are from silverado to tahoe though

 

[Hurlz07Tahoe]

12.5" wide tire is 317.5 mm. I don't think I have seen that wide a tire on an NNBS yet with a level kit. Wonder if that would clear the UCAs?

I would look like a beast if you can pull if off. Post pics!


I running a leveling kit with stock 20s and 305/55/R20s (12" wide tire) and don't have any problems at all after only minor trimming.