i have normal monroe shocks on it now but the springs are designed to be used with nivomat shocks and is bottoming out alot right now along with setting low in the back
if anyone could get a gm part number i can get my repair shops discount at the dealer and hopefully be cheaper
---------- Post added at 08:35 AM ---------- Previous post was at 08:30 AM ----------
why im needing these is i cut my z71 coils to lower it then it road like crap so i picked up...
i been looking for a set of oem rear nivomat shocks for awhile now with no luck i called the dealer asking for a set and they had no idea of these shocks i was wanting they kept telling me they are a/c delco shocks, does anyone have a gm part number for these or a way to purchase a set some were...
have a k&n 57 series FIPK cold air intake for a 4.8 5.3 6.0 tahoe or silverado this intake has about 3,000 miles on it looks like new has all hardware needed to install $200 shipped
mine is a z71 tahoe but i have normal LT tahoe coil springs in the rear due to me being stupid and cutting coils off on my old z71 coils, im thinking the best rout to go is just oem shocks what did they use i never had oem shocks on mine to know
I recently replaced my back shocks with some blue cheap monro's shocks and now rides terrible has a lot of swaying i have to hold onto my seat going around corners along with ruff ride, i did some searching and couldn't come up with what i needed. What part number are you guys running on the...
You might see slight difference in throttle response without doing full headers and new exhaust all the way back might not see much difference along with you will run into o2 sensor issues with the check engine light on, i am not sure if the o2 after the cat helps with air fuel mixture of not
i would do this check list
-connecter going to compressor
-the ground wire is good on the wiring harness to the compressor
-the switch that controls when to shut the compressor off and on its what the leveling rods are connected to
to remove the autoride you will have to install normal socks on it and i would just remove the fuse for the compressor and the leveling rods that are connected to the control arms
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.