I noticed one of my bolts has a bend in it now ... and I'm at work but I will measure them in the morning and follow up . I didn't think much into the bolts because I took a gear reduction off and replaced it with the same . And I don't think it was bent before .
99 Yukon with a l31. Yes it tested good and throws it out . It just seems like it isn't reaching out far enough . The gear has no wear or signs of hitting flex plate , still has the paint on it . I have two starter currently and neither of them work . They are both the new style starter
Bought a new starter for my Yukon . I have shimmed it . No shims ,it just sounds like it's free spinning . I took it back to o reilys and it tests fine .. is it possible a new starter can't reach the flywheel? The gear looks like it has zero contact still. Is there any other possibilities ? I...
First I apologize if I named this wrong or posted in wrong place .. so I was replacing my starter when I noticed that my ground cable that connects to the starter and goes up to the battery is falling apart . As I took the old starter off the wire actually broke in half . Is there a replacement...
You just have to add extension to it . And no I have not . The original intake was taped together . Instead of clamped . I had to get a new battery today and I drove it and it's better then it was . I just thought it was odd because it never pulled codes . I checked the throttle cable and made...
I bought a 99 Yukon a while back and the stock intake was barely hanging on . So I found a cheap spectre cold air kit and put it on . You have to rewire mass air flow sensor and now I have a high idle . I'm not pulling codes . But some days it's ok . Some days it's really high . It's not my...
Does anyone happen to know which mode actuator is for a 99 Yukon. My air is stuck on defrost in the front and I have seen a few different ones. Thanks guys
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.