strutaeng's latest activity
-
I was a GM technician for 30 years. I still tinker and do complete renovations, at my own pace. -
What did I miss that indicates a lean condition, other than the MAF value? The MAF reading in the pics is 0.04 lb/min, which equates to...
-
I'm also leaning to a vacuum leak but got to rule out possibilities.
-
start testing battery, battery cables and grounds.
-
strutaeng replied to the thread live data dump. what do YOU see?.Lean on idle that improves (especially if only one bank) points to a vacuum leak. I didn't see all the data, some of it had glare. Just...
-
strutaeng reacted to Edwards1337's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with
Like.
I've checked for short to ground on the purple wire in the rear, it's not resting at ground. I've I take my meter and put positive lead... -
strutaeng reacted to TJ Baker's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with Like.
Mine was quite clearly toasted...
-
strutaeng reacted to TJ Baker's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with Like.
This sounds like you have the automatic control system that uses a solid state blower speed control.module. This is not truly a...
-
strutaeng reacted to Edwards1337's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with Like.
Even with the truck off? The diagram I found I traced essentially everything where the orange 12v lead runs up the d pillar, across the...
-
strutaeng reacted to Edwards1337's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with Like.
Gonna start out by saying I've been chasing this issue for a few weeks now, dozens of hours on forums and online, and checking stuff...
-
strutaeng reacted to mikez71's post in the thread 06 Yukon REAR HVAC won't shut off -update, WAS resistor - SOLVED with Like.
All I know is, when I unplugged my headliner wires to remove the headliner, the rear hvac ran full blast. Have you looked at wiring...
-
I would suspect it was put in loose and just worked around till the threads were ruined. It happens. You are correct the GM LS heads...
-
Heat gun. Slowly pry them off with either your fingers or carefully with a plastic pry tool and a microfiber towel against the paint...
-
strutaeng replied to the thread New Cylinder Head Question.Do you know why was the spark plug blown out? That's not a common issue on these engines AFAIK. Did the piston make any contact with it?
-
I had my #7 cylinder spark plug leave the head. So I am replacing the head. I tried to helicoil it and no go. So I purchased a newly...
