nonickatall's latest activity
-
nonickatall replied to the thread Amp gauge.Are you sure? Normalwise the charge controller delivers the voltage/ampere which is needed to charge, apprx. 14,8 Volt, but never more... -
nonickatall replied to the thread Amp gauge.Its not an amp gauge its a volt gauge. If you gauge shows more that 14-15V you have a defective gauge, what is not very likely, because...
-
nonickatall replied to the thread Bad trans or transfer case?.Do you still have propulsion when you switch to D? Pobably not, otherwise your wife wouldn't have the need to be towed. Foe me it...
-
Recommend doing a wet compression test to determine if the rings are the cause, and the air leakdown test. Also, you could check for...
-
nonickatall replied to the thread Oil Consumption.That what make me concerned is that i have a loose of compression in this cylinder. I checked the car for leaks, but i have no spots on...
-
I did not see the crack you were speaking about. I believe the valve stem seals are shot by looking at the videos. Also you will see...
-
nonickatall replied to the thread Oil Consumption.Yes properly I have a head gasket problem because there is also a consumption of cooling liquid. What leakdown procedure do you mean?
-
nonickatall replied to the thread Oil Consumption.Here you can see the place I'm talking about. The dark spot right on the valve seat and the dark groove above the dark spot, where it...
-
-
I looked at 1, 2 and 5. I think you have a blown head gasket on 5, it's washing the piston clean. I'm not well versed enough with LS...
-
nonickatall replied to the thread Oil Consumption.I now found the time to care for my car and i guess my engine ist finished and need an overhaul. :oops: The engine runs good, makes no...
-
Added a resistor to the correct wire and everything works! Thanks for the input folks. Next to add resisters to the front so that I...
-
I'm an old wrench turner that's worked on a ton of stuff over the years, I'm certain that this is not a mechanical noise like cavitation...
-
nonickatall replied to the thread Brake pedal chirp.As far as the chirping noise is concerned, I would actually guess it's the V-belt or some bearing that's chirping. The fact that this...
-
nonickatall replied to the thread 5.3 slap. Treat it or leave it?.I had a louder clicking noise in the hydraulic lifters on mine and I got into the habit of adding 1 liter of diesel to the engine oil...
-
nonickatall reacted to mhaywoodcz's post in the thread 2002 denali front diff failure/vibration with
Like.
Update, the other shop rebalanced the drive shafts, they ended up removing weights and adding some others. Seems the first shop didn't...
