-
-
Llspann3525 replied to the thread P0172 and P0175 2008 Tahoe.Ive been doing a little research and I see that these engines have a high pressure fuel pump under the intake manifold that can cause...
-
Llspann3525 replied to the thread P0172 and P0175 2008 Tahoe.Update: The other morning I started the truck and the engine light was off. However the next day or 2 the check engine light came on
-
Llspann3525 replied to the thread P0172 and P0175 2008 Tahoe.Ok cool they should be connected correctly. The only o2 that was removed was the passenger side top to get to the exhaust nut.
-
LWell Im back again my truck has been running pretty good with no oil leaks since the rear main seal replacement. But I am now getting a...
-
Llspann3525 replied to the thread Rear main Seal.Yep. Ended up having to addng a gallon of transmission fluid and now it's reading in the crosshatch area almost to hot probably will...
-
Llspann3525 replied to the thread Rear main Seal.Finally got everything back together and started the engine up a few times yesterday. No leaks so far. Now it's time for the...
-
LI bought a pulley holding tool at NAPA and used an old belt to protect the pulley on the crank shaft. It works fine rested on the frame...
-
Llspann3525 replied to the thread Rear main Seal.I see what you were saying now. Wasnt aware of that little barb because I never disconnected any of the hoses. But after carefully...
-
LHere’s a couple pics of a 6l80e, it looks like that vent tube attaches on the passenger side towards the front, up top.
-
Llspann3525 replied to the thread Rear main Seal.Found the diagram..the hose labeled number 2 is the hose I am talking about. Everything from the Bell housing vent bracket is correct. I...
-
-
Llspann3525 replied to the thread Rear main Seal.Started plugging the electrical connectors and vacuum lines back in. Headed to the store to get some wire loom to finish this up. I'm...
-
Li had enough fun stabbing my t-56 back in after a clutch swap on my LS1 in my 20's. nothx on t-cases or auto transmissions.
-
LLiving in Virginia now, I sometimes think about going back to 2WD, but I love skiing too much and at least three times while maneuvering...
-
LIf anybody had to do that with the old time late 70's Dodge/Chevy full time cast iron full time T-cases raise your hand. I had to do...
-
LYeah they’re hard to R&R. There’s nothing I could do except bench press mine after dragging it up onto my chest. Not fun and I’ve done...
-
-
Loading…
-
Loading…
