Fless
Latest activity Postings About
-
-
Ya mine worked out of the box but later discovered the rear would only heat if it was set to 90, at 89 it would just go back to cold... -
Fless reacted to Doubeleive's post in the thread 2004 Tahoe 5.3 flex fuel intermittent hot rough idle and stall - SOLVED with
Like.
Yep those maf can cause all kinds of problems, been there... -
Fless replied to the thread Valvoline Restore & Protect experiment.I know, it's not on you. Just an a-nal observation.
-
Fless reacted to Eboz's post in the thread 2004 Tahoe 5.3 flex fuel intermittent hot rough idle and stall - SOLVED with Like.
Update. Put in a brand new Delphi maf that I got on Amazon for 90.00 with a legit serial number. Fixed the issue and fixed my...
-
Did mine without dropping diff or driveshaft. (engine cooler & transmission cooler lines) I bent the old trans cooler lines to...
-
Fless reacted to DodDel5-3-6L80e's post in the thread Engine oil cooler line removal question with Like.
I changed my oil lines yesterday on my 2011 SSV 4X4. I did not have to remove the differential like someone said. It threads through...
-
Fless replied to the thread BREAKING: GM is officially recalling the L87.Might want to edit the 2001-2004 years to 2021-2024...
-
Fless reacted to Joseph Garcia's post in the thread 2009 gmc yukon denali l9h 6l80 driveability issue with Like.
Welcome to the Forum from NH. Lots of knowledgeable folks here who freely share their knowledge, experiences, and perspectives...
-
Fless reacted to rdezs's post in the thread 2009 gmc yukon denali l9h 6l80 driveability issue with Like.
1. Did you perform the CASE relearn with a Tech 2 or bidirectional scanner? 2. Were the phaser, actuator, crank and cam sensors genuine...
-
Fless replied to the thread Valvoline Restore & Protect experiment.Off the subject a little, when did we go back to using two-digit years? I would think after all the Y2K hysteria we'd be using 4...
-
It's probably all related. You still need to to check that circuit and see what alls on it as a start to figuring it out.
-
Fless reacted to Saucy_Walnuts's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Swapped out my bad axle in my 03 Yukon with a good one from a 01 tahoe. 3rd Pic is the axle I took out and 2nd Pic is right before I put...
-
Same here, Ebay. I did not have to program my replacement module, possibly I just got lucky with the same options.. (On my second used...
-
Fless replied to the thread 2001 Tahoe, Cranks no start, no spark.Consider doing the CASE relearn after replacing either sensor. Even if the engine runs decently, a mis-correlation between the two can...
-
Fless reacted to Firebirdracer82's post in the thread 2001 Tahoe, Cranks no start, no spark with Like.
I finally found my code reader. It appears I have two stored codes for crankshaft position sensor circuit. P0335. I may go pick one up...
-
-
Loading…
-
Loading…
