'25 Yukon AT4 U - rear license plate frame interferes with camera

[kwisatz]

Ok, just noticed on my Yukon that the rear license plate frame from my old vehicle does not fit under the camera/sensor cluster...frankly the dealer plastic frame doesn't fit well, but being plastic is bends enough to line up the screws. Anyone else see this issue... I've been thinking of getting the Reviver ePlate, but paranoid now it wouldn't fit...

 

[OR VietVet]

Ok, just noticed on my Yukon that the rear license plate frame from my old vehicle does not fit under the camera/sensor cluster...frankly the dealer plastic frame doesn't fit well, but being plastic is bends enough to line up the screws. Anyone else see this issue... I've been thinking of getting the Reviver ePlate, but paranoid now it wouldn't fit...

Hopefully help will reply soon.

Welcome to the forum from Oregon.

 

[LegalBrief]

Went thru this… rear license plate frame of any kind will tweak rear camera holder cause it vision angle to be off…. No obvious work around

 

[BacDoc]

Same thing happened with my wife’s Honda. Trimming the frame of the bracket/frame worked for me. This was an aftermarket frame that didn’t fit in the area of the camera and a little trimming with a dremel allows the frame to fit around the camera.