Search results

  1. J

    Show off your 2015-2020 lowered tahoes and yukons

    17 4WD 2-4.5 or so.
  2. J

    Sway bar and shock

    1) I may have to look into that. 2) Springs are Belltech 34324 3) Yes. Not 100% sure the sway bar is hitting the shock, but something is hitting and causing a rattle noise. Its not a loud noise, just hear it in parking lots, alleys, etc.
  3. J

    Sway bar and shock

    Yes, it is lowered around 4 inches or so. No shock extenders as I used Belltech drop shocks instead. FLipping the shock will worsen the scenario, right? The thick part / body is at the top now. I will look at the adj panhard bar. By chance does anyone else have pics of their rear set up? Also...
  4. J

    Sway bar and shock

    For those that lowered the rear and used the offset sway bar end links, how close is your passenger side shock to your sway bar? I have a rattling at low speeds that i can hear, and i believe the sway bar is hitting the shock. When sitting, there is about a 1/4 inch or so between the two. I...
  5. J

    Front higher than back....

    Thanks for the thorough explanation. It is greatly appreciated. Regarding the other question, I do not have MRC as this is a SLT with no air ride, etc.
  6. J

    Front higher than back....

    Thanks. I had it realigned after changing the spindles, and it had no problem going back to spec. I know with the struts or springs, the camber is affected a bit. I assume though, since its just an inch or less, there might be enough wiggle room without having to use a caster / camber alignmment...
  7. J

    Front higher than back....

    I lowered my 17 4WD Yukon recently. Used belltech spindles and model # 34324 springs, DJM offset sway bar end links, bell tech shocks instead of using the shock relocate brackets. I believe the springs I used are the same as the 5305 springs(which I believe Norcal provides) just a newer model...
  8. J

    Lowering question on 17 Yukon...

    Is there a trick to doing the free travel mod on the driver side? With the tank there, I am a little leary to use a plasma cutter or a sawzall? How did you do it?
  9. J

    Center console question / favor

    Hi... I recently purchased a 17 Yukon SLT. However, the rubber cup holder base and the rubber mat piece in the little square section in front is missing. Anything in either of those sections slide around and drive me crazy. Can anyone please look and get me the part numbers on those pieces? I...
  10. J

    NORCAL SS Custom 2/3.5-4.5 for all 2wd 2015+ GM SUV

    Do you guys normally add drop shocks to these kits? I know the rear uses extenders, but what about the front? Should you just replace all 4 since you are already there anyways?
  11. J

    Lowering question on 17 Yukon...

    Hi, I recently purchased a 17 4WD Yukon. It's a SLT and has no air ride. I want to put a 2/3 on it, maybe a 2/4. I was looking at the max trac springs that include the shock extenders. Any thoughts on those? Rough ride, too soft, etc? I believe the springs are the same on both 2wd and 4wd. That...

Forum statistics

Threads
129,225
Posts
1,812,419
Members
92,327
Latest member
Jake 2015 GMC Yuk

Latest posts

Top