West 1's latest activity
-
West 1 replied to the thread TPMS question.All the TPMS sensors I have installed worked right away. I would have them installed at a local tire shop and to save money I always... -
Air all 4 tires to 42 psi & see if the warning goes away, if it does it just means the tire psi you've chosen is lower than the ecm...
-
West 1 replied to the thread TPMS question.I have used these off Amazon about a dozen times now including my current Denali. I did have one sensor that would not program brand...
-
West 1 replied to the thread 07 Tahoe LTZ gas in the oil.Since you already have a set up to supply 100 PSI fuel. Get an injector electric connector, OReilly sells them, set your connector up...
-
You may want to use new o-rings on the injectors when you reassemble. Still need to determine if the alcohol percentage in the PCM...
-
Tried backing em off. No change. No plugs. Yeah, battery is on a charger. The problem with that is im using 2, 15 foot long cable's that...
-
West 1 replied to the thread 6.2L Winter Refresh.Did you use 100PSI on your leak down test? I only ask because some guys use less air for the test. 8 PSI leaking at 100 is only 8%...
-
West 1 replied to the thread 6.2L Winter Refresh.Test it on another engine, off by 90 psi is way off. A leak down tester will put 100 psi in your cylinder and show if it is holding or...
-
West 1 replied to the thread 6.2L Winter Refresh.Rules that out.
-
West 1 replied to the thread 6.2L Winter Refresh.How was your piston deck height?
-
West 1 replied to the thread 6.2L Winter Refresh.Your cam card shows 113* lobe separation, that will build compression and give a flat torque curve. Engines that bleed compression...
-
West 1 replied to the thread 6.2L Winter Refresh.if you have a leak down tester you could check a cylinder to see if there are leaks at the valves, rings or head gaskets? ON a new...
-
West 1 replied to the thread 6.2L Winter Refresh.The piston rings need oil to seal on the cylinder wall. You might put a squirt in a cylinder and test again.
-
West 1 replied to the thread 6.2L Winter Refresh.Did you remove the tape from the intake ports as you checked compression? I would think you are looking for close to 200 PSI in your 6.2L.
-
West 1 replied to the thread [SOLVED] Help appreciated finding my oil leak.That is a lot of work to have done for $4500. Not too bad. I hope it all works well now.
