Recent content by tomustang

  1. T

    Service Suspension on after 2 months of rear airshocks replaced

    Since the valve was in the compressor I ordered a new one. Came 1 day shipped with rockauto, I was impressed. Turns out the previous compressor I bought in 2017 has a lifetime warranty but they didn't have any stock so I have the option to get a refund out it. The replacement fixed the problem.
  2. T

    Service Suspension on after 2 months of rear airshocks replaced

    As for the comp vent valve, since the short to ground code is showing I'm assuming the actuator is inside or attached to the compressor? I'd test some wiring but I don't know which wires to test. The first code could just be me fiddling around with the connections and seeing if everything's...
  3. T

    Service Suspension on after 2 months of rear airshocks replaced

    Plugged in a scanner and got 2 codes: C0585-04 Left rear actuator circuit open C0660-06 Level control exhaust valve circuit short to ground/open
  4. T

    Service Suspension on after 2 months of rear airshocks replaced

    The pump has been replaced about 2 years ago when it was first showing signs it was going out (getting louder) How the fuse/relay be bad if the pump still turns on? Before I posted I did a quick turn on and the pump ran, threw on a trailer for weight and watched it drop down and stop at...
  5. T

    Service Suspension on after 2 months of rear airshocks replaced

    2008 Yukon Denali, Stock Suspension I have replaced the rear air shocks which were blown out at the bottom with Arnott AS2708's back in May without issue. For a week now I've been getting the Service Suspension message off and on. When I look back at the air shocks I can see the bags aren't...
  6. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    It did plug-in-play though all the functions worked, besides the a/c issue.
  7. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    Got it back from the dealership. Turned out to be a bad wire from the low pressure switch, it was reading low signal on their tester and traced a broken connection somewhere In the middle of the wire. All is well now.
  8. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    Ended up testing a different high pressure a/c switch and hvac control module, not difference.
  9. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    I appreciate the offer, however I'm further up north. I haven't scheduled to go into the dealership so they could do the diagnosis and I can go from there, if it turns out to be something like the ECM I'll just trade it in.
  10. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    To reiterate the HVAC controls. I start the car cold, for 15 seconds the high speed fans are off, i turn on hvac power, I have recirculation function, and Automatic isn't forced on. After 15 seconds the high-speed fans turn on, and when pressed the recirculation and AC buttons flash 3 times...
  11. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    ELM327. I have replaced the engine temp sensor, the a/c pressure sensor, and have swapped out the two sensors behind the bumper that monitor outside air temp
  12. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    Ac was always ice cold, the system just stopped automatically one day, even when I jump a 12-volt source to the ac compressor with the car running it's still ice cold. I threw a A/C recharger on and showed full. No leaks anywhere. There is no codes. I don't have a way to test high and low...
  13. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    I've bought another AC sensor to see if the other one was bad. Does anyone know if they're supposed to be constant power going to the AC compressor, because I'm not getting any juice, I don't know if the reason why the fans are on if it's cutting the power to the compressor or not
  14. T

    Engine cooling fan always on when running, a/c-recirculation 3 blink

    There's a new belt on it, I've already jumped the compressor with an outside 12v source and it blows cold air inside

Forum statistics

Threads
129,262
Posts
1,812,985
Members
92,364
Latest member
Ep33401
Top