osirus5164's latest activity
-
osirus5164 replied to the thread Trans pan 08 tahoe.@NickTransmissions how close would the mating surfaces be before applied force would be necessary? The new harness is pretty stiff so... -
osirus5164 replied to the thread Trans pan 08 tahoe.Is that referring to the seal that goes into the pump? If so, yeah. It has been replaced
-
osirus5164 replied to the thread Trans pan 08 tahoe.It's a deep pan. Measures same as the old pan with the addition of a drain plug because why would anyone in their right mind omit that...
-
Just finished my first 4l60e rebuild and went to put on the pan but she sits about an 8th is from being flush. Appears to be hanging up...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions long break. Uses sent the correct bearing on a cross country trip that took it a week and we got a puppy. Haha...
-
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions I think you were dead on with the bearing. Could I have put the correct one somewhere else on accident, or is it...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions I put everything together last night and everything looked good but when I slid the shaft back in and tried to put...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions morning, hope all is well. I have gotten to the rear sun gear (had to wait on a snap ring I thought I bagged) and I...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions yeah I kinda changed directions on the fly with this one but it makes sense. I just wasn't sure what kinda pressure...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..Later thought I had was to maybe take off. 015-.030 off the spring retainers to expose that spring just a hair. Feasible?
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions so I ended up switching to a 7 friction setup as it was advised that the 9 friction might not be the advisable on...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions so I have a stack for .036 or .032 clearance, I imagine either one is splitting hairs at that point. Load release...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..Just the clearance to about.028, I think. I suck with the dial indicator but if I left up and hold my calipers to it I am seeing about...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..@NickTransmissions funny story, I think my kit came with the alto power pack as well as stock .80 frictions, not sure why. So narrowing...
-
osirus5164 replied to the thread Knee deep in first transmission rebuild, opinions welcomed..Top notch information, as always. Transparts is sending me the proper replacement and I think part of my goof was incorrect snap ring...
