-
-
Jjeffg replied to the thread Complete Spohn rear end 2007-2011 $300.I am on my 2nd round of adjustment. They seem good for a couple of days and then get noisy again. Did you ever use thread locker or...
-
Jjeffg replied to the thread Help me here please.I wouldn't discount bad grounds. I had a bad ground when I did my engine swap and I had all kinds of stuff going on. Stupid things...
-
Jjeffg replied to the thread Engine harness plug identification.Finally got all of the wiring sorted (stupid dummy fuse in the fuse block), and the LQ9 is running. Holy crap. I don't know if the 5.3...
-
Jjeffg replied to the thread Engine harness plug identification.Thank you for checking. I haven’t put the rad support back in yet. Hopefully it will be obvious once I do.
-
Jjeffg replied to the thread Engine harness plug identification.I am going to start it on the factory flex fuel ecu and tune, but it will be headed to the dyno for proper tuning after break in.
-
Jjeffg replied to the thread Engine harness plug identification.Turns out the mystery plug on the passanger side plugged into a sensor on the AC line just in front of the compressor. Engine is ready...
-
-
Jjeffg replied to the thread Engine harness plug identification.I think that handles the ground. I will update if I find the home for the smaller plug.
-
Jtop of frame in the front towards bumper
-
Jjeffg replied to the thread Engine harness plug identification.I already have the ac clutch plugged in. It’s on the same branch of the harness as the ac clutch. The ground I am looking is the...
-
Jjeffg replied to the thread Engine harness plug identification.Also, the smaller ground cable from the battery. Where does that go to?
-
Jgetting close to having the engine in and ready. I have a couple of plugs I can’t remember where they go. Any help identifying these...
-
-
Jjeffg replied to the thread Complete Spohn rear end 2007-2011 $300.Are these still available?
-
-
Loading…
-
Loading…
