I put that 917-107 clamp on. I need to get a new gasket to see if it actually helps. Pretty neat item!
Will headers or y pipes that fit 5.3/6.0s also fit the 6.2 or are they different?
anyone know of some decently priced headers/ypipe/exhaust type setup? longtube or shorties. not looking for a huge perf increase, think I need cats. I'd be ok with a y-pipe that bolts up to the factory location as well (with no cats, or high flow?).
thank you. the 917-107 seems like what I would need(pretty neat too!), but does not show it as fitting the 6.2 for 2007.
does not seem to be leaking from the broken bolt location however (pass side front bolt).
Put new plugs in today. It was wayyyy over sure. Average gap on them was .080"! Pass rear plug was a little difficult to get at, but removing the wheel well liner made it pretty easy.
Found it has a broken exh manifold stud (front one) on driver's side.... Bummer!
Next up is driver side abs...
replaced my pcv clean/dirty lines. seems to have helped with my idle issues (would hang a little when driving). they were cracked pretty bad and leaking a lot of air.
I've been playing with it some. But there is a lot of stuff, and I don't know all of the acronyms etc haha. I've gotten some of it down. But there's quite a bit more I need to learn.
Best tuner that I can use on the truck? I'd like to eventually get a tune for it, but for now just so I can bump...
both my 'fresh air' pcv valve hose, and my 'dirty air' pcv valve hoses are cracked etc. The dirty air one i can actually hear sucking/blowing air, if I fiddle with it it stops. I seem to be able to find the 'clean air' pcv one pretty easily online.
The dirty air one I am struggling to get a...
Replaced the valley pan and vlom orings(original ones were quite flat), intake manifold gasket, oil pressure sensor. Zero change with my oil pressure when hot at an idle.
Not sure what else is left other than trying a quart of lucas. Oil pump i guess. Doesn't seem like it would be that to me...
I'm planning on replacing the swaybar/swaybar bolts. Right now theres nothing there at all lol, just the busted bolts. BTDT as well, I'm from up north. Love living down in the south, where my 16 year old vehicle with 170k miles isnt a rust bucket lol. I just took my exh manifold bolts out with a...
I got Alldata diy and from what I've seen in there that 1 large connector seem to be a suspension relay. the wire next to it is the one in my photos i've posted that looks melted. Thats probably why it doesnt have active air anymore.
Is the rear air/front air tied together? Or do they operate...
changed out exhaust manifold gasket, plug wires, valve cover to new style valve cover/gasket.
drove it about an hour today, lowest I saw oil pressure hit was about 13psi in gear/idling at about 550rpm. still see close 35-40 psi at about 1100 rpm cruising
going to do the intake...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.