Think I'll stick to the instructions like you did. Just wanted to make sure I get everything before I start. I'll add a torque wrench to the list. Good idea with the cleaning. I know it's a real mess under there.
I've been following this thread. I've diagnosed my oil pan gasket as leaking for sure. Just want to make sure I get the right gasket and figure out if I should or should not use RTV sealant. Definitely don't want to have to do this twice.
So I have pretty much convinced myself to keep the hoe and swap in a 6.0. The problem is I don't know enough to do the swap myself let alone rebuild a motor if necessary. Anyone know of any shops that won't completely rip me off??
Yes I intend to replace the other side in the near future if I still have the hoe. I have been looking for something newer lately but haven't found anything I like.
So for an update I did resolve my vibration issue. To get to the point it was the drivers side wheel bearing. It became easier to diagnose as the noise became louder and I could tell it was from the drivers side. After checking everything else on the front end I went ahead and replaced the...
Thanks for the reply Chubbs. I did some looking around again today by myself and tomorrow I should have someone that can help me. The noise is certainly louder this past week so I am getting more concerned. I am debating on replacing a lot in the front end due to the mileage and from what I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.