SunlitComet
OBS Jedi-Do Good
Line 20 when attached to 21 should have vacuum on the side of line that attaches to solenoid you pictured tho it may be hard to feel with ahose of small diameter. DDid you do the volt test?
What should I do next for my heat to work? heres a diagram and what ive done...
- Thread starter knoslf
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
knoslf
Full Access Member
idk its dark now but ill check the line for suction while disconnected from #19 on the firewall, if the line is plugged you think that could be the issue? Couldnt fine my little tester but will 2morrow or buy another ont....
SunlitComet
OBS Jedi-Do Good
Uh, yeah.
knoslf
Full Access Member
Just checked #20 on the solenoid end(while the other end is on #21) and there is strong suction on that end...cant find my tester...the solenoid is the second one, took one off another truck like mine for $2 and thought i'd try it but
SunlitComet
OBS Jedi-Do Good
test that wire as soon as you can then.
knoslf
Full Access Member
Okay, checked the wire and there is power going to it, tested the one from the junkyard and it had power too...
SunlitComet
OBS Jedi-Do Good
what position was the temp dial in with power to it and not. with ignition on and blower on any setting setting except off.
knoslf
Full Access Member
The temp dial was all the way on 'hot' in the red....the blower motor was on high/ignition on too...idk what the issue might be now
SunlitComet
OBS Jedi-Do Good
With that line 20 connected to engine an water valve solenoid did you get a vacuum onthe hose that goes from solenoid to water valve? And what volvoltage did you get when the temp dial was set to max cold detent and a/c control on?
knoslf
Full Access Member
No vacuum on the hose that goes from solenoid to water valve at all, dont recall the numbers from the test as a friend did it for me
Similar threads
