HoeRyder26
Member
Heyy guys Bryan here and I have a few questions for ya. I'm getting readthe to do a water pump on my 03 Tahoe lt 5.3l. And while I have the water pump sitting around is there anything I can do to keep it clean after the install, as in a clear coat or a color to keep it from oxidizing. I hate when cast/aluminum gets that powdery coating on it.
Also I figured while I was in there I would degrease the entire motor and trans. I'm even to the point where I want to take the coil brackets off and respay them black and clean up all the plastics.
Are there companies out there that make dress up parts for our engines (billet pulleys, coil pack brackets, engine covers)? Especially once I do the electronic fan conversion the motor will all be visible so I want it to look clean.
Also I figured while I was in there I would degrease the entire motor and trans. I'm even to the point where I want to take the coil brackets off and respay them black and clean up all the plastics.
Are there companies out there that make dress up parts for our engines (billet pulleys, coil pack brackets, engine covers)? Especially once I do the electronic fan conversion the motor will all be visible so I want it to look clean.