Side molding removal. pics?
- Thread starter jmyler
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
thumper_ehhhhh
Full Access Member
Here's a few of my 04
Before
During
After
This is what I used along with goo gone. I let the truck sit in direct sunlight for a bit then just ripped them off. For the flares I had to pop out the gromits in the wheel well first then ripped them off too. I still have to do the debadging. It wasnt hard at all. Took maybe 1hr per side.
---------- Post added at 10:29 PM ---------- Previous post was at 10:27 PM ----------
One of the mods will move it for you.
Before
During
After
This is what I used along with goo gone. I let the truck sit in direct sunlight for a bit then just ripped them off. For the flares I had to pop out the gromits in the wheel well first then ripped them off too. I still have to do the debadging. It wasnt hard at all. Took maybe 1hr per side.
---------- Post added at 10:29 PM ---------- Previous post was at 10:27 PM ----------
One of the mods will move it for you.
BogeyBoy82
Full Access Member
Depending on the mileage/weather around your truck its possible that you will notice a variation in color under the mouldings.
thumper_ehhhhh
Full Access Member
i do have some marks where the flares rubbed. Most people dont notice it. I need to get out the rubbing compound to remove them. Im in SOuthern Ontario so we get weather from 100f in the summer down to -10 f in the winter. Lots of salt on our roads too. I think it depends on the color of your truck. With mine being beigeish that hides alot.
