Quick question about adding DIC (drivers information center)
- Thread starter BEEMDUB
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
depends on which interior you have. It's the entire center plate and most of the part numbers are here...
http://www.tahoeyukonforum.com/forum/showthread.php?t=27019
orange72blazer
TYF Newbie
- Joined
- May 10, 2013
- Posts
- 20
- Reaction score
- 0
Good to know, I need to do this upgrade also.
---------- Post added at 09:19 AM ---------- Previous post was at 09:17 AM ----------
Was it a new switch or used, I have been looking on ebay but can't find anything.
Good to know, I need to do this upgrade also.
---------- Post added at 09:19 AM ---------- Previous post was at 09:17 AM ----------
Was it a new switch or used, I have been looking on ebay but can't find anything.
Boom
---------- Post added at 10:42 AM ---------- Previous post was at 10:34 AM ----------
orange72blazer
TYF Newbie
- Joined
- May 10, 2013
- Posts
- 20
- Reaction score
- 0
thanks
Well I wasn't too excited about paying 130 bucks for a painted piece of plastic so I dremeled out a slot in my existing trim and leather wrapped the part that the switch goes in...is it perfect? no..but it'll do until I have 130 extra bucks to blow
c5corvette
Member
- Joined
- Jul 29, 2011
- Posts
- 77
- Reaction score
- 0
Can someone tell me instructions to remove the long piece of trim described here?
ghostworks
Full Access Member
It is just clipped in place, so you just pry it off, I used a platic tool created for removing interior trim, but I guess almost any long and thin tool would work. Just work your way around the edge of the trim until all the clips are loosened
Similar threads
