MagnaRide Delete Woes...

[Pumping Pete 01]

2019 Yukon Denali 4WD with Z95 MagneRide, 110k miles. I attempted a Bilstein 5100 conversion but discovered the factory MagneRide spring won't fit the Bilstein body. I'm now trying to figure out the best way to rectify the situation. Shockmasters recommended the Bilstein 4600 and a Front Strut mount kit. I am guessing the spring would still need to be moved over at this point.

Is there anything I am missing? Trying to be cost effective here, but not go cheap.

 

[SpareParts]

Post some pics of the problem showing the problem.

 

[Pumping Pete 01]

Well, that's the other problem. I took it to a local alignment shop to install it and they were explaining to me that everything was looking like it was going to fit but the strut was too thick for the bottom piece (I didn't see it myself). Asked me to just bring in an entire strut.

 

[Doubeleive]

Well, that's the other problem. I took it to a local alignment shop to install it and they were explaining to me that everything was looking like it was going to fit but the strut was too thick for the bottom piece (I didn't see it myself). Asked me to just bring in an entire strut.

just hit up a auto dismantler for some standard struts, then swap in your new 4600's