Hey there.
I recently purchased a 2016 PPV.
Of course I am left with a rats nest of wires that I am tracing and removing bit by bit. Tonight’s task was to track down, what appeared to be a charger mounted to the push bumper. I’m removing this I disconnected the positive and negative terminals one from each side.
I also changed my oil. When I got into the car. It’s notifying me of potential ice. It’s currently 98 degrees. The temp display on the screen is reading 32 degrees. The wiring to the ambient air sensor looks good. Though I was tugging on some wires through the grill. But they didn’t run near the sensor.
Could this be a programming issue? I’m lost at the moment on how to trouble shoot this. Any insight would be appreciated.
I recently purchased a 2016 PPV.
Of course I am left with a rats nest of wires that I am tracing and removing bit by bit. Tonight’s task was to track down, what appeared to be a charger mounted to the push bumper. I’m removing this I disconnected the positive and negative terminals one from each side.
I also changed my oil. When I got into the car. It’s notifying me of potential ice. It’s currently 98 degrees. The temp display on the screen is reading 32 degrees. The wiring to the ambient air sensor looks good. Though I was tugging on some wires through the grill. But they didn’t run near the sensor.
Could this be a programming issue? I’m lost at the moment on how to trouble shoot this. Any insight would be appreciated.
