The transgo shift kit "can" help with that. I had delayed shifting, but it was a broken spring inside the transmission valve body. The kit can also allow you to tighten the shift band inside. The kit explains it. Also, the valve body separator plate probably has one or more check balls trying to...
@DoubleDingo How did it go? Get comfortable with the process and be prepared for your new "GM" sensor to fail. My 2004 sensor lasted 21 years. The new GM sensor failed in 4 months, then another a few months after that. I'll tell you that removing the intake manifold makes this job super easy!
At 187,000 I replaced the separator plate and installed the Transgo shift kit and the 2005 Tahoe went another 54,000 miles. One shift spring was broken inside the valve body and the separator plate had one check ball almost rammed through. All done with transmission still in truck. Really...
If it is a rotational pulsating whine it can only be so many things. When it starts again pop the hood and see if you can determine where it is and record the sound. Belt pulleys are typical.
Replaced the original oil pressure sensor a few months ago and then it suddendly went **** up, the first one lasted 21 years. Bought one for the Tahoe and one for the Yukon at the same time. The tahoe one is working, but the Yukon one now reads pegged 80. Both from RockAuto. GM# 12677836 made in...
From another forum: If its blowing a fuse it has a short to ground somewhere.
Another forum: IF YOU HAVE CHECKED FOR A SHORT THEN MOST LIKELY YOU HAVE A BAD INJECTOR. YOU CAN UNPLUG ONE INJECTOR AT A TIME UNTIL IT STOPS BLOWING FUSES OR YOU CAN TAKE IT TO A REPUTABLE TECH WHO CAN HOOK IT UP TO A...
Not burning oil. Sounds fine idling and at speed after cat replacement. Also have the 862 heads, so not sure about coolant burn. Just did a quick spray of carb cleaner to see if there are any vacuum leaks. It didn't change the idle or I didn't spray enough in the right areas, so I want to do a...
Have an 04 and 05 and both clusters failed. Had to send them off to ISS automotive to be rebuilt. Both vehicles have Hydroboost brakes, but the reman cluster for the Yukon always gives the error that I need to "service brake booster" which this vehicle does not have. That's the only issue with...
I had wet carpet on driver's side in the 05 Tahoe and it was from where the body panels are joined, right below the windshield and where wiper trim and hood hinge are located. If you look there you will find the seam. There is one on each side. I found the best sealant I could get at the time...
Has anyone else experienced failed cats on bank 1? The original stock cats failed a while back, with a broken piece rattling around. The second set was a cheap brand from Rockauto and again bank 1 failed by plugging solid. Any thoughts or suggestions of what the causes might be will be appreciated.
Transmission pump or Torque converter will need to be ruled out.
From another Forum:
The pump is turning with the engine so it's always pumping fluid. In park and neutral there is no demand so a cavitating pump will make noise but it will be louder in gear.
When diagnosing transmission noise...
Hope you got a warranty from the transmission person. Going that deep into a transmissions rebuild, you would think valve body solenoids would have been replaced along with all the other springs, o-rings, seals.
"he is very sure it's not his transmission that is causing the problems",
Said...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.