@Doubeleive I thought about that. Do you just pop off the cap that covers the axle nut? Frankly, I need a bigger breaker bar.
For now, I gave up on driver side and reassembled everthing. The driver sides actually seems pretty tight. I will keep an eye on it. I also needed the truck and thought...
By the way, When noise started happening from time to time. we brought it to the GMC dealer in Ohio. They took if for a drive, lifted it, checked it out. Then told us they could not replicate the noise and everything seemed fine. And since they could not find anything, they did not charge us...
I am in the process of replacing front bearings on my 2004 z71 tahoe with about 145,000 miles. I replaced one side that was so far gone that when I lifted front end, i could shake wheel. Very scary.
Doing the other side now but having problems getting axle nut Off. Will work on that later...
I don't think there ever is a good time for a breakdown. I have been lucky and they have often been on nice days. The Tahoe has not yet broken down on us though...
my thought on this is that when hoses get old, they get hard. So under vacuum, they would most likely fail if under vacuum (since usually under pressure). If they fail, I would rather them fail while i am in the garage changing the coolant than on the open road.
I am good there, too many actually. I have two oil compressors, one portable. 30 and 80 gallon more or less. Intent was to run them at same time if I needed the CFM, sand blasting or other. but usually only use the small one.
Yeah, What he said :)
I had a VW once that I drained the fluid and had a hell of a time getting rid of the air. Figured this was the way to go. When you consider the cost of doing it at a garage, it paid for itself already. Plus you can use it to test radiators (off vehicle) etc.
Correct. Hooks up to your compressor to make vacuum by creating a venturi effect. The device connects to the expansion tank (or radiator if you have older vehicle) and a screw expands the rubber gasket to make the seal. You would need a compressor.
https://www.amazon.com/Airlift-Cooling-System-Checker-Airlock/dp/B07BT3978C/ref=sr_1_6?crid=8B8NLP1798US&keywords=airlift+coolant&qid=1649071958&sprefix=airlift+coolant%2Caps%2C77&sr=8-6
You drain system, Put on the fitting, pull vaccum. All hoses will collapse and you can test for leaks...
Did it Saturday. It took forever to get the damn clamp off the lower radiator hose. It is a big one. Luckily I had bought a tool that keeps it open for duration of the operation. I did not know about water pump hoses. Keep that for next time. But the coolant was nice a clean coming out. I only...
Hi have to change the coolant in a 2004 Tahoe z71 with rear heat. In order to properly drain the truck, do i need to do anything to open up valves for heater core (front and rear) prior or during draining?
The FSM says to pull the lower radiator hose off radiator. I have also seen posts about a...
The circled area is where I heard what sounded like a vacuum leak. Again the propane did not have a noticeable change in RPm. Is this normal? I saw someone use water to locate vacuum leaked. I may try this next.
So I am gettin the dreaded P0171 P0174 Bank 1 and 2 too lean codes. Truck is a 2004 Z71 Tahoe 5.3Z engine. Truck is running smooth. No misfires or anything. So far, I have:
1. Replaced the air filter. I was not able to reset the air filter indicator but I hear those typically are not reliable...
I do not like the FSM from GM. Extremely hard to navigate and tremendous amount of wasted space. They repeat the same images over and over. If you really want it, you can find it online for free from others. But I am used to Toyota manuals that are very well written.
I agree it does not hurt...
I have a 2004 z71 tahoe. I need to replace a stepper motor and some lights in the cluster. I was wondering if anyone did this on their own and where they got the parts for. Here is what I want to do:
-Replace the skin to include Tranny gauge. (I was looking at a white background but wanted to...
This is the description of this oil:
$25/10qts. Kirkland Signature™ Full Synthetic 5W-30 Motor Oil is formulated to reduce wear on critical parts and maximizes fuel economy. Our 100% synthetic formulation provides long-lasting engine protection and performance. For use in gasoline, flex-fuel...
Hi. I am thinking of switching to synthetic engine oil on a 2004 z71 Tahoe with about 137,000 miles. It has been well taken care of and has no leaks at all.
I picked up some Costco synthetic oil but after someone mentioned that there is a possibility that it could start leaking, have been...
I had no idea about the sync issue. Since i never got the hatch open, i never even thought about the wiper issue. Ok, I will mess around and see if I can figure it all out. thank you!!!
My glass (top part) never opened on mine. I know there is fix for it but never got around to fixing it.
Thanks all for your help. Will work on replacing with OEM or similar wiper.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.