Search results

  1. Y

    [SOLVED] Help with Power Steering!

    Hoping you guys can help with the latest twist on my 2004 Yukon. Proud original owner! I've got no power assist, and a burst line that looks to be the cause. If you look at the attached pic, it's the line going in to the steering box to the right of the steel line also heading in to the box...
  2. Y

    Leaking fuel line 2004 Yukon!

    Hi folks it's been a while since the car's been running Ok but a new prob has come up and need some advice. first it's a very rusty NJ 2004 Yukon that I've owned since new. I've done a lot of the work over the years, including replacing the fuel pump and main fuel lines, and also brake lines...
  3. Y

    Transmission slipping!

    So I've got a 2004 Yukon that I've owned since new, it has 150K on it and it's really served me well. a workhorse that I depend on! now the trans is slipping and over revving, it almost feels like there's no third gear. sometimes it's OK and drives fine then it will slip and rev to 5k then back...
  4. Y

    Replacing steel rear brake lines!

    Hi guys -- back for part two of this project! A while back I came here for some advice on replacing the front line which had rusted out and let go (thanks again all). like the proverbial "other shoe" to drop, the rear finally went. good news is I already have the part as part of the GM kit I...
  5. Y

    Bleeding Brakes after replacing steel lines

    I'm original owner on a 2004 GMC Yukon w/4WD, and I'm one of those poor souls whose steel brake lines rotted out and had to be replaced. I got the "kit" from GMC, it fit fine, did the job myself. Replaced everything up front from the Master Cylinder on down to the pads including new calipers...
  6. Y

    Finished the job and now it won't start!!

    Very frustrating! I experienced a pretty bad power steering leak on a trip, nursed it home, found a leaky pump. replaced the pump and high pressure line. all set. then I turn it over and it wont start. battery was disconnected for the entire job so that wasnt an issue. I know I was messing...
  7. Y

    bleeding brakes after line change

    So I finally wrapped up changing the steel lines in my 2004 Yukon after a burst line and brake failure. used the pre-bent GM kit and it was time consuming but relatively straight forward. also did the rubber lines, rebuilt calipers, pads/rotor. so everything's new. bled with a vacuum bleeder...
  8. Y

    Bleeding the brakes

    I had the steel front brake line go as seems to be common with these, and just wrapping up the replacement. I used the GM pre-bent kit and it turned out to be time consuming but not too hard. now here's the question -- is bleeding just like normal? I've heard ABS complicates things. I did...
  9. Y

    Replacing steel brake lines 2004 Yukon

    Hi -- new to the forum and found you guys in my search for an answer to this question. I've read the background and done the homework, so I understand the basics. My 2004 Yukon suffered the same fate as many -- burst front line when going to stop while pulling up to the Arrivals at Newark...

Forum statistics

Threads
137,853
Posts
1,993,701
Members
102,825
Latest member
EricBeau

Latest posts

Back
Top