Search results

  1. Doubeleive

    *fixed* Radiator cracked on plastic, how do I know which radiator I need

    the Denso 2219011 is 1.33" thick that's as about as thick as you can get them it's $173.00 on rock auto
  2. Doubeleive

    *fixed* Radiator cracked on plastic, how do I know which radiator I need

    any 2000-2014 34" gm radiator, the only difference is if it has a oil cooler or not and if you do not have a oil cooler you can use one with it anyway because the oil cooler section is sectioned off, just like the transmission cooler section is. so anything from 00-14, whatever is on sale OEM is...
  3. Doubeleive

    It’s a goner, isn’t it?

    first thing I would do is take both belts off and see if the noise goes away, doesn't sound internal to me but hard to say from a video
  4. Doubeleive

    What did you do to your 2015-2020 K2XX Tahoe/Yukon Today?

    I took them for a little spin didn't try anything too crazy but they seemed ok. I like my eagle sport a/s on the Denali but they only go up to 20" I picked the AS07 after a bit of research and pricing, they fit my budget and they were easy to balance per the shop
  5. Doubeleive

    What is this ?

    Should have metal cover over it and there should be one on the other side kind of directly up from where the sway bar d bushing is and there should be a connector for it on the wiring harness
  6. Doubeleive

    Pegged engine oil gauge

    height may certainly play a factor, I am 6'4 so all I needed was a pick tool, flashlight, the sensor socket (thin wall) and a ratchet & short extension. used the flashlight to see the harness clip orientation, used the pick tool to release the harness, used the socket to r&r, then looked again...
  7. Doubeleive

    Bouncy Soft Rear Suspension Auto Level 2019 Yukon XL

    I take it they did not offer the option for advance replacement? even if they did it probably would have been a nightmare getting credited back for it. that company has a very long bad history, do not recommend........ good luck with replacement if it happens, I would not be surprised if they...
  8. Doubeleive

    Front impact sensor

    they should be the same so whatever type you removed from the vehicle, the same should go back in. using something different may have a different ohm reading resulting in the same error. I am not sure what the difference is in a UT looked it up Resistance Values: The internal resistance of a...
  9. Doubeleive

    Front impact sensor

    if there is a junkyard in your area you can get one super cheap and there usually already easily accessed because people pull the engines and so the parts are already just laying around basically. I have 4 spares in my tool box, they fell in my pocket
  10. Doubeleive

    Front impact sensor

    I meant swap left side/right side the part is the same for both sides, if you swap sides and the code follows then the sensor is bad if the code remains on the same side then there is a electrical problem of some form. connector, broken wire, etc.
  11. Doubeleive

    Pegged engine oil gauge

    absolutely no need to remove the intake, this is a 5 minute job on a gmt800
  12. Doubeleive

    Front impact sensor

    both front sensors should be the same, you did not provide a year at some point not sure which year might be 2010+ gm changed how they are mounted, which could be why maybe a previous owner changed it to a different one? regardless you could swap left & right and see if the code follows, your...
  13. Doubeleive

    06 Suburban LTZ No Turn Signals but hazards work

    testing procedure https://charm.li/Chevrolet/2006/Suburban%201%2F2%20Ton%204WD%20V8-5.3L%20VIN%20Z%20Flex%20Fuel/Repair%20and%20Diagnosis/Lighting%20and%20Horns/Testing%20and%20Inspection/Symptom%20Related%20Diagnostic%20Procedures/Turn%20Signal%20Lamps%20and%2For%20Indicators%20Inoperative/...
  14. Doubeleive

    LED Running Board?

    More like $1000 and add your own led's
  15. Doubeleive

    trying to save my ex's 2015 Suburban

    and like I already said the starter is suspect as the tech noted I would pull it and bench test it's easy 2 bolts and a couple wires. if it throws sparks that's your clue lol
  16. Doubeleive

    trying to save my ex's 2015 Suburban

    if and once it starts, I would change the oil pronto, followed by the coolant, plugs and wires, new air filter. at minimum, plugs and wires might not be critical but oil and air filter are.
  17. Doubeleive

    trying to save my ex's 2015 Suburban

    the $199 diagnostic you posted a photo of noted the 300amp fuse was blown. That fuse is part of the BATTERY TOP panel, that whole panel is one big fusible link, each red power connector on it has it's own separate rating, so like 175amp, 125amp, 100amp, etc. If you look at it closer you will see...
  18. Doubeleive

    trying to save my ex's 2015 Suburban

    the throttle body is aluminum that is just from moisture and sitting
  19. Doubeleive

    It’s a goner, isn’t it?

    This reminds me of when we were shopping for a rig for the wife, a car dealer had a denali listed for a price that was within my range. when we showed up it was not visible anywhere and I when I asked about it the sales lady said she would have someone bring it up front, I heard them start it...
  20. Doubeleive

    trying to save my ex's 2015 Suburban

    meh it's not that bad, someone had it under a tree with the hood up, hence all the pollen and leaves, the "white" stuff is just from moisture. all the connectors are fairly water tight.
  21. Doubeleive

    trying to save my ex's 2015 Suburban

    don't go back there, that guy didn't want to work on it. from the pictures it does not appear to be all that bad, it has been exposed to moisture and has been sitting otherwise standard dirty engine compartment. put those intake connectors back on, pressure wash it. pull the starter and bench...
  22. Doubeleive

    It’s a goner, isn’t it?

    drove around tapping for 2 year's hmm
  23. Doubeleive

    2019 Yukon Denali questions

    it really depends on what the problem is if it will throw a suspension code or not, usually they do not. the shocks could be blown out and no code as for plugs & wires, OEM is the way to go, get them from a well known source lots of knock-offs (fakes) out there
  24. Doubeleive

    Is there a way to tighten the mirror glass to stop vibration?

    on the gmt900's it clips on to the motor with 4 clips, if the glass alone is wiggling then the motor is either broken or worn out etc. the clips slide down from the top
  25. Doubeleive

    Is there a way to tighten the mirror glass to stop vibration?

    I would try just a motor then, either new or junkyard, it's the one for the glass up/down/left/right new ones are not cheap, best bet is junkyard...
View older results

Forum statistics

Threads
137,671
Posts
1,989,103
Members
102,675
Latest member
j_jerry79

Latest posts

Back
Top