What I have found to work well with this type of tool is to put a good amount of pressure on it and let it sit a bit. I have had several instances where after a bit of time left in place, it pops on it's own. A little heat and some percussion on the knuckle can work well to help it if needed...
I will for sure. I had to take a trip out of town so unfortunately the tool will collect dust for at least a few weeks before I get to try it. :/
Unless I run into some kind of unforseen fitment issue I have no doubt it will work. The smaller version worked great on the uppers, and on several...
I found one that should do the trick. 32mm fork opening. Build quality is very nice on it, too. I much prefer leverage and the right tools over swinging sledge hammers.
https://www.amazon.com/gp/product/B08MCCSGC9
I am replacing the entire lower control arm with a new ball joint attached...
Hi All,
I am attempting to swap out the lower control arms and I can't seem to find a ball joint separator with a fork wide enough to fit around the 23.24 mm lower ball joint shaft. The one I have is 19mm, and the largest I can find is 22mm. (With the exception of possibly some very expensive...
Hi All,
I'm digging into my stock (2001 Tahoe Non Bose) stereo to see why the subwoofer and d-pillar tweeters aren't functioning.
Whomever worked on it previously bypassed the amp and wired up the front speaker outputs to BOTH the front and back doors by splicing wires into the harness from...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.