strutaeng's latest activity
-
Did you replace the intake manifold or the gaskets for it? I was debating doing that next but I've already dropped 1200 over the weekend... -
It is parked I have 4 other gmt800's to drive until its fixed. I mainly listened for injector pulse with a mechanic stethoscope. I'm...
-
strutaeng reacted to commercialfshrmn's post in the thread Watch what you buy from Amazon or eBay with
Sad.
fake amazon ngk's here, too -
strutaeng reacted to Double J's post in the thread Watch what you buy from Amazon or eBay with Like.
Recently ordered a water pump (AC Delco ..no GM option available) and thermostat (GM) from Rockauto and both came in official packaging...
-
strutaeng reacted to swathdiver's post in the thread Watch what you buy from Amazon or eBay with Like.
I buy parts from Ebay from GM dealers or like driveline shops that also have their own website and brick and mortar store. No issues...
-
strutaeng reacted to intheburbs's post in the thread Watch what you buy from Amazon or eBay with Like.
Nothing critical for my vehicles is purchased off eBay. I only buy from auto stores, or Amazon (and only from a dealer or auto parts...
-
So, I've been dealing with a slight annoying rough idle issue for as long as I can remember. I've shot the parts cannon at this thing...
-
strutaeng replied to the thread P0300 misfire on 1 3 5 7.Have you check the injectors to make sure they are pulsing? Or how did you check them? I know they say to check with a noid light, but...
-
I'm going to ohm test all the injector wires and coil wires back to the ecm to see if I have a disconnect. I'll let you know what I find.
-
going through the same thing right now w/ an 07. only things i haven't replaced are the MAP & PCV. it's driving me NUTS!!!!!
-
That sounds exactly like an electrical contact problem, because it often happens when you have, for example, a broken wire and the wire...
-
It certainly sounds like a problem with your left cylinder bank, since cylinders 1,3,5 and 7 are all on the driver's side. The only...
-
I've looked at alot of other post and couldn't find something similar to my current issue. I have a 2004 Yukon XL 1500 5.3l slt. I was...
-
strutaeng replied to the thread Introduction post.Welcome! Always good to have guys here with knowledge and experience working on these vehicles.
-
welcome to the forum, brother. if you wanna keep yourself busy for a minute, go read my last thread showing live data & tell me...
