My 2008 Yukon XL w/5.3 LC9 flex had to be replaced with a long block at 166k miles. I was smart and did the water pump at that time too.
I have 222k on the vehicle now but I have been using the Range device since the new engine was installed. No oil issues or problems.
I have been using only E85 for many months. Just completed my 2nd 3000 mile roadtrip. Year round in Indiana. I feel the power bump and get 12.5mpg combined instead of 14-15 for gas. Besides wasting corn, I love E85, and have had no problems. I have less than 60k on the Engine, but the rest...
I was bad and let the oil run down about 3 quarts low twice... Eventually the rings on one of the pistons froze up so i was running on 7 cylinders. The dealership said they could free them up but they would just freeze up again soon. I got a complete LC9 long block (5.3 flex) with the...
Yes, I will be doing the GM install, but I need to wait until they offer Saturday service again or get a tech in on a Saturday to do it, unless I can figure out how to get it there during the week with working. Now I need to be sure it's not the pre-assembled strut, but them getting all the...
That was taken on our trip to Key West from Indy over the Christmas 2021 break. Behind me 90 miles is Cuba. On the edge of the beach on the Southside of Key West.
I agree. The problem is, both are same price, but the Monroe at the Tire place I go to is 4 miles away and open on Saturday, and the GMC Dealership I get a 20%+ discount at is 25+ miles away through traffic and not doing service on Saturday anymore.
Hard decision. Convenience or GM Factory...
Hi. My 2008 Yukon XL w/200k needs shocks/Struts. Do I install Monroe or the factory equipment? Price is about the same for me; I get a discount at the dealership.
Thanks!
Gary
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.