-
-
Pproject_x reacted to Saucy_Walnuts's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with
Like.
Swapped out my bad axle in my 03 Yukon with a good one from a 01 tahoe. 3rd Pic is the axle I took out and 2nd Pic is right before I put... -
Pproject_x reacted to Tonyrodz's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Finally got a Z71 front lower air dam with fog lights. Not sure if I want to use it now. I won't be able to add the lower add on lip to...
-
Pproject_x reacted to rockola1971's post in the thread 2003 tahoe stalling & fuel smell in cabin with Like.
Your scanner told you likely what is wrong. Your Bank 2 sensor 1 (Pre cat sensor) is one of the 2 O2 sensors that your PCM uses to...
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.It was my upstream o2 sensors...I'm surprised they both quit at the same time.,, but they are replaced and my fuel trims have adjusted...
-
Pproject_x posted the thread EVAP System.... found an o-ring where is it from? in Engine & Drivetrain.I pulled my EVAP system apart to fix my fuel filling. Blew out fuel vent line. Checked purge valve, checked vent solenoid... it looks...
-
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.I replaced Bank 2 Sensor 1 and it looks like that corrected the problem.... now I need to get Bank 1 Sensor 1 loosened... it is stuuuck
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.I also see voltage on one of them (bank 1) sometimes... Bank 2 seems to be 0 or 4mV
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.My scanner says it switches to closed loop.
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.MAF is cleaned no change. My upstream 02 Sensors are mostly reading 0... but I can't believe both are bad... I have a spare that I will...
-
Pproject_x replied to the thread 2004 yukon denali interior plastic paint.
-
-
Pproject_x replied to the thread 2004 yukon denali interior plastic paint.I had the same interior colours. I tried to match and got something too light at first... And then used SEM 17223 Very Dark Pewter...
-
Pproject_x replied to the thread Fuel Trim wonky... where to start.I will clean the MAF. They look about the same... And I've seen as much as 30%
-
PI recently did a ton of maintenance on my Suburban. I installed a new transmission, transcooler, transcooler lines, and rad. I cleaned...
-
Pproject_x reacted to mattbta's post in the thread What did you do to your NBS GMT800 Tahoe/Yukon Today? with Like.
Drove it 90 miles round trip to Dickies Arena for a concert with my daughter. Always a good time with her. Hardwired the dash cam...
-
PGood tin snips.
-
-
Loading…
-
Loading…
