Recent content by NorwegianHoe
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
The lug nuts were super stuck on, tried everything from brute force and jumping on the wrench. Ended up rounding these two old bolts. Bought one of these extractor/twist sockets, hammered it on and used a proper breaker bar with a pipe on it. Loud bang and it was off. Easy to remove the broken...- NorwegianHoe
- Post #43,059
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Got it working today! The new contact for the brake switch came in the mail and I did some wiring. One of the wires were super thin and the plastic had gotten hard, nearly cut it all of when trying to strip it back. I work with wires every day, so I should be capable enough, but this one made me...- NorwegianHoe
- Post #42,840
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
Fixed the brake light switch. This one does not have a spring, the contacts act like a spring, and it had become weak. Bent a little bit and checked that I had one N/O contact and two N/C contacts. Cleaned up with a dremel with a wire wheel (overkill, use sandpaper) When I went to install it...- NorwegianHoe
- Post #42,823
- Forum: General Discussion
-
What did you do to your NBS GMT800 Tahoe/Yukon Today?
New stepper motor for speedometer. Sometimes the speedometer went crazy. Don't know why I did not do it earlier, super easy fix with a soldering iron. Also, one of the previous owners installed some fancy lights and a lightbar, the wiring is a mess and my lights keep shorting out. Some of the...- NorwegianHoe
- Post #42,764
- Forum: General Discussion
-
2005 Tahoe Ticking
Any updates on the low RPM situation? I have quite similar symptoms as you, p0300, low PRM, stumbling, sometimes hear what I believe is a vacuum leak. Bought a new intake manifold gaskets, so we'll see.- NorwegianHoe
- Post #44
- Forum: Engine & Drivetrain
-
All bank 2 cylinders misfire
Just found out my filler hose is not even attached, did your fix and going to test tomorrow as it's late here. Thanks for this documentation (Probably not the cause of my terrible p0300 tho, but I'll sleep in the hope tonight)- NorwegianHoe
- Post #11
- Forum: Engine & Drivetrain
