NORCAL SS

i have a 98 tahoe with a whipple super charger and was looking for info about it dose it use gear oil and were would i put it any advice would be great thank you

@NORCAL SS Is there a way to lower the rear of a 2015 Yukon Denali with autoride height by only about an inch?

@NORCAL SS here are my cuestions : 1. would the rear free travel mod would help me in the rear, 2. would the norcal mod help me fit 305/45/22 in the front? 3. would the spring bags in the rear help? or please send me yout suggestions thanks for your help//

@NORCAL SS good day i just lowered a 2008 tahoe ls 5.3, used the beltech 753 drop kit, with the belltech 9534 shock pack, did a 3 inch with the shock in the front, and a 3 inch drop in the rear, currently running 285/45/22 in the front, they slightly rub in revese with full turn, &305/45/22 in the rear, i get some rubbing in the rear well with 5 people on board, here are the questions:

@NORCAL SS , I was referred to you by @M3kanic . I am looking to get a set of Airlift 1000 bags for my 07 Yukon. However, it has been lowered 3 inches in the back. do you know which set (vehicle, or universal size) I should get? I have a Belltech kit with their springs. Thanks in advance!

I recently got my Tahoe back from some repairs due to an accident a couple years back, long story, 2" front 3" rear. It was 2013! I believe my rear shocks r in need of replacing. There is sway going on that wasn't there b4. How long do u recommend b4 swapping out shocks. What about the kit itself? How long b4 u would swap it out if at all? Cant find receipts. Would the 8521 front and rear be good all the way around?

Do you sell a kit to lower the rear only on a 2007 suburban 2500?

Hello. I purchased a 2013 Tahoe PPV 2wd and wanted to drop it a bit. I was reading somewhere that these come from the factory already dropped over the stock 2wd LT. Is this true? I bought aftermarket rims but used the stock 17" tires. I don't want to change the suspension geometry too much but would like to lower it at least a couple of inches all the way around. Can I just buy a dropped spindle and rear spring kit?

Howdy, just checked out your TBSSowners site and some threads. Definitely will be calling you in the next few days. Currently started a large project on my Tahoe.

Hey Tony just ordered a spohn panhard from you , wish i would have joined this forum before I ordered other stuff. But look will the djm rear hardware kit work with Belltech shock extenders. could i sandwich the shock extender between then relocator bracket? Or could i grind/cut off the top end of the shock extender and drill a new hole like the djm shock extenders?