Recent content by MotoEric
-
Electrical gremlins- BIG ones!
So….today I’m on the interstate after dropping off a bike for warranty service. As I’m pulling on to the ramp the door locks start cycling, the dash lights up and the OBDII port goes dead. warning lights on: CEL Stability ABS gauges: d-dead j- jumpy o- on speedo- d tach-j Fuel - j volt -o...- MotoEric
- Thread
- Replies: 3
- Forum: Engine & Drivetrain
-
LR ride height sensor ?
I’m still looking for the LR ride height sensor referenced above. 2011 part won’t fit, LOTS of options for front sensors, but nothing for LR. I’d consider aftermarket at this point..... anyone? Help!- MotoEric
- Post #2
- Forum: Street Suspension
-
Air ride bleed off?
I wasn’t clear enough on that. Both sides are high, and level. The shocks are new ( Arnott 2708) and the compressor is new ( Dorman). everything was fine before hooking up the trailer. I have some more hauling to do this week. When that’s finished I’ll do the line disconnect and see where I end up.- MotoEric
- Post #6
- Forum: Street Suspension
-
Air ride bleed off?
Many thanks. GM parts direct does NOT have the part in stock. I know this because I bought it from them, then when I inquired about a delivery date was told they didn’t know (after charging my CC instantly). To their credit they issued a credit in a reasonable timeframe.- MotoEric
- Post #4
- Forum: Street Suspension
-
Air ride bleed off?
As I’ve posted below I bought my ‘12 XL Denali knowing that it had a LR ride height sensor throwing a code. What I didn’t know was that the part is on a National backorder. So far no one has suggested where I might look for one, the usual vendors are showing no stock. I needed to move a bike...- MotoEric
- Thread
- Replies: 5
- Forum: Street Suspension
-
LR ride height sensor ?
My ‘12 Denali has been throwing a C0625 code, * LR position sensor circuit malfuntion*. I knew this when I bought the truck, but didn’t know that part ( 20917434) would be on national back order. I’ve looked on the obvious parts sites w/ no luck. Any ideas? thanks, Eric- MotoEric
- Thread
- Replies: 1
- Forum: Street Suspension
-
New to the site, old to the platform
The selling shop installed them, (and new tyres) because the OE wheels had suffered the effects of upstate NY winters. I have the takeoffs and may try to give them a quick refinish and run them in the winter. All I know is that they were purchased at a Mavis location around here. And yes, 20’s...- MotoEric
- Post #3
- Forum: Introduction
-
New to the site, old to the platform
Eric here, here being the Finger Lakes in upstate NY. I started w/ a Suburban in ‘94, then a few XL Denalis and a ESV. I found a 1 owner, clean CarFax , ‘12 XL Denali in Tricoat. So far so good. Feels very familiar...and somewhat surprising given that it’s been ~ 15 years since my last one...- MotoEric
- Thread
- Replies: 8
- Forum: Introduction
-
-
New guy, trailer wiring question
Thank you, thank you! It was the (15a) fuse.... let’s hope they’re all this easy. if I can answer any tech questions on MotoGP, F1 or World Endurance fire away!- MotoEric
- Post #6
- Forum: Audio & Electronics
-
New guy, trailer wiring question
2012 Denali w/ Z82 factory tow. At the 7 pole I have directionals, brake light, 4 ways, but no tail lights or running lights. The PO never ran a brake controller, both the red wires under the hood are untouched and there’s nothing on the terminal posts. Any chance that those must be connected...- MotoEric
- Thread
- Replies: 33
- Forum: Audio & Electronics
