Recent content by maniacmurray

  1. M

    How to seafoam!

    Yeah I did read page 1..... I was asking if someone knew the proper procedure? First off I know that you are suppose to let it sit for about 15 mins Before restarting it and also I'm pretty sure that you don't floor it or goose it while the vaccum line is sucking up the Seafoam! If I'm not...
  2. M

    Rattling sound during acceleration

    It could be wheel bearings, u-joints or the rear end!!! Like the others said, get it checked asap!!!
  3. M

    oil pressure?

    Well I've been drag racing, doing mods on engines since I was 15 and I can honestly tell you that by not pulling the crank out and at least having it checked then you are asking for trouble man! If the crank is scarred in any way it will chew up/burn or spin s bearing quick! Be safe and listen...
  4. M

    Just got a '99 Yukon

    Thanks!
  5. M

    How to seafoam!

    Ok guys! I just bought a '99 Yukon with a little over 200k miles on it and I plan on doing the Seafoam treatment to it, gas tank, oil and vaccum line! Can anyone with the correct procedure please let me know how to do it? It has a 5.7L Vortec in it, 2wd, automatic. Thanks, Frank!!!
  6. M

    Just got a '99 Yukon

    I just bought a 1999 GMC Yukon. It's gray exterior, gray interior! Has aftermarket exhaust even though, I'm gonna put putting on Flowmaster shortly, 5.7L Vortec 350, auto trans w/overdrive, 4 door, leather interior, 2nd row seating, front brush guard, side tube type steps, 15x10polished aluminum...
  7. M

    I need help please!!!

    I have a 2003 Tahoe and need to know where to buy/find a new ac/heat selector switch that changes the position of the direction of air flow to the front. It's the far right switch/knob on the dash where the air flow speed switch is located! All help is appreciated and welcomed, thanks!!!
  8. M

    Ac/heat position switch not working!!!

    I have a 2003 Tahoe LT with dual climate control (manual) and tri-zone ac/heat! The selector swtch to change from feet, defrost & feet, dash, dash & feet etc.. is not working! It seems to stay on dash only and will not switch over to anything else, even defrost. The other ac/heat controls work...
  9. M

    Pics of a few of my other rides!!!

    Ok guys, no pics of the Tahoe just yet, but coming very soon. Here are a few pics of some of my other rides though, enjoy!!! The S10 had a 468 BBC w/748 hp and I was too scared to run it all out, but would turn a 10sec 1/4 easy w/out even trying hard, lol. The Olds Cutlass is now...
  10. M

    Dogs, Puppies, post em up

    Here's my American Bulldog, Dana. She is now about 5 yrs old and just had her treated with the heartworm injections and now on a scheduled dosing of heartworm preventative!!! She's my other baby, lol. ---------- Post added at 06:10 AM ---------- Previous post was at 06:06 AM ---------- I...
  11. M

    Chip Question???

    Ok guys, I was told I have a chip in my '03 Tahoe and was wondering other than performance wise how can I tell or find it if there is one? Where do I look? It runs like a scalded ape and when I first got it I ran beside a Cadillac STS at a stoplight and pulled away until about 80mph, then he...
  12. M

    What's the most amount of time you've spent detailin your Yukon/Tahoe

    If I do a full detail and start bout 10am then I'm normally done around 4-5pm w/short breaks....
  13. M

    rims cleaning

    Try Eagle 1 Etching Mag Cleaner, especially in all those hard to reach areas if you don't have the time to yank off the rims to clean!!!
  14. M

    Wheels..

    Eagle 1 Etching Mag cleaner, works well on all steel, aluminum and chrome wheels. Just spray on and spray off w/a water hose. Not sure how it works on painted rims, i.e. black, etc...
  15. M

    favorite tire dressing

    I use the Black Magic Tire Wet (Gel) and it looks great and I live down a dirt road?!?!?! It's relatively inexpensive and I carry it everywhere I go in my Hoe. I use a rag or sponge to apply it and that way you avoid overspray onto the rims, etc...
See more

Forum statistics

Threads
137,702
Posts
1,990,018
Members
102,698
Latest member
JamesinAbilene

Latest posts

Back
Top