Recent content by MalcDogg
-
P0300 code after replacing parts
This is what I found the steering sensor is off alignment go get a wheel alignment- MalcDogg
- Post #33
- Forum: Engine & Drivetrain
-
P0300 code after replacing parts
I have no idea why the push rods was bent I replaced a lifter then was still getting a misfire so something told me to check the rods they was fine when I replaced the lifter and took it for a test drive- MalcDogg
- Post #32
- Forum: Engine & Drivetrain
-
Low Oil pressure still!!!!
I took off the valve covers and I don’t have the updated valve covers Order them today The oil pressure starts between 20-40 then after driving for 30min it goes below 20 never gets to zero I do get a lot smoke from tail pipe on start up that’s it goes away after 5min engine is running fine...- MalcDogg
- Post #18
- Forum: Engine & Drivetrain
-
Low Oil pressure still!!!!
Starts high but after driving for 30min it goes low never to zero- MalcDogg
- Post #17
- Forum: Engine & Drivetrain
-
Low Oil pressure still!!!!
- MalcDogg
- Post #16
- Forum: Engine & Drivetrain
-
-
-
Low Oil pressure still!!!!
Yes has a new screen and sensor- MalcDogg
- Post #12
- Forum: Engine & Drivetrain
-
Low Oil pressure still!!!!
I have 08 Tahoe 5.3L Changed the Oil pressure sensor, Pick up tube, High volume oil pump installed and pressure relieve valve and still getting low pressure anyone got any info? I did notice the pan was dirty I’m reading about the oil filter to use the AC Delco filter- MalcDogg
- Thread
- Replies: 24
- Forum: Engine & Drivetrain
-
P0300 code after replacing parts
I installed new valves and seals I should’ve replaced the guides too The valves got bent from hitting the tops of the pistons do to bent push rods- MalcDogg
- Post #27
- Forum: Engine & Drivetrain
-
P0300 code after replacing parts
Now that I got everything done and new parts I’m getting smoke from tail pipe a lot of smoke on start up looks white but really light blue color and smells like burning oil but then goes away and come back after sitting idle then I can hear an internal backfire any ideas on that? But the...- MalcDogg
- Post #25
- Forum: Engine & Drivetrain
-
P0300 code after replacing parts
Turns out a few valves was bend and valve seals was damaged leaking oil in the cylinders causing random misfires- MalcDogg
- Post #22
- Forum: Engine & Drivetrain
-
P0300 code after replacing parts
No I didn’t do I delete and I used all new parts- MalcDogg
- Post #21
- Forum: Engine & Drivetrain
-
-
P0300 code after replacing parts
Well here’s an update Went back into the engine replaced the valves and am the seals everything seems to be working fine a get a misfire then it goes away a lot of smoke coming from the tail pipe when I sit and then take off seems like it’s burning away the carbon build up from me cleaning...- MalcDogg
- Post #15
- Forum: Engine & Drivetrain
