The car dealer I bought the rig from 'found' another key and fob so I am good with that for now. I cut out the dash panel for the DIC switch with favorable results. So I am good there as well.
The cruise control won't set. I have switched out the brake switch with no improvement. If the rain...
Well.........I have the keys, fobs, and the DIC switch. I removed the access panel and found the DIC wire bundle neatly stored as designed. However when I plugged the switch in and ran through the options, no key/fob programming option appeared. I am guessing maybe this is not available by...
Behind the glove box I found a connector with 3 lite blue wires opposed to 3 red or red/black wires. I have read about a box being located here. Again no voltage showing
I found the rear wires. Mine were cut very close to the bundle so I did not see them right away. Currently mine are not showing voltage to ground.
This may be due to three 'fusible links?' I found in the glove box.
Where should the links live? Under the dash or under the hood?
Bill, Thanks for your reply. I have keys and fobs coming. I will try programing one of the keys as the rig is now. When I get the DIC panel installed I will do the fobs.
Okay on the wiring, your comment makes sense.
Thanks again.
Thank you Sparksalot.
I have looked in the jack compartment and did not see wires. I will lood again.
I would like to access this power for some ham radio installations.
Ok on the DIC buttons I will order one.
Recently purchased Tahoe. The front middle seat/armrest has been replaced with a 'standard' tahoe or yukon armrest unit which reaches forward to under the dash. There are a few wire looms/bundles dangling. What/where did they or do they go?
I do not have the DIC buttons on the dash. Can I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.