-
-
JJisnis replied to the thread 37s on Budget - will this fit?.I’ve come to the conclusion that I’ll have to go 35s
-
JYou’re definitely going to need more lift and more fender trimming. With that offset, you’ll rub the UCAs, but that’s not the end of the...
-
JJisnis replied to the thread Show off your 2015+ leveled Tahoes and Yukons!.I’ve gone through the entire thread and didn’t see anyone run a negative offset. I’m looking to run a 17x8.5 -10/-12 wheel with...
-
JJust posting up because I wasn’t able to find many examples of this setup on this gen Denali when I was deciding what to get. I had fuel...
-
JJisnis reacted to Marshall 008's post in the thread UAC lift kit, Tuff Country, wheel selection with
Like.
I’m huge fan of RRW wheels. I have the I have the RR7-H in bronze with 0” offset. They sit just right for me and don’t poke out like... -
JJisnis replied to the thread 37s on Budget - will this fit?.Thanks. I saw his thread. Just wondering if others would have an idea given the specifics of what I’m trying to accomplish.
-
JCurrently have a 2015 Yukon XL Denali with Maxx Suspension 2.5” level kit in the front and 1” in the rear. I currently have wheels/tires...
-
JJisnis reacted to mcasey5121's post in the thread Will a 2”Level kit allow me to fit by 275/65/20 on 2015 Yukon XL with Like.
Leveled my 2015 and run 285s. Only slightly rubs when turning extremely sharp. Trimmed a little with a razor knife after it marked a...
-
JIt’s so nice to drive now with the new gears. I’m still breaking them in, but it’s not bogging down going up hills now. I feel better...
-
JJisnis replied to the thread Arnott AS3066 vs AS3429.Was there any visible height differences when compared to stock?
-
JJisnis replied to the thread Arnott AS3066 vs AS3429.What are your thoughts on the Arnotts vs the stock? Looking to replace my tears as well.
-
-
Loading…
-
Loading…
Forum statistics
Latest posts
-
Easiest way to install manifold clamps? Dorman Manifold clamps- Latest: Scott in AZ
-
-
-
-
