I have a 2008 Tahoe Lt 4x4, 132k mikes. This morning when I was driving it I noticed the oil pressure gauge wasn’t holding a contestant pressure. It would go from 40 to 20 then back up to 40 the needle in the gauge just kept moving constantly. When I would slow down real slow to turn in...
So I pulled off the wheel and caliper today and checked my pads there fine, and the slider bolts are lubed fine. BUT I ran in to bigger problem, I had to push the caliper pistons back in to get the caliper back on the rotor, after I done this I pumped my brakes up and I can’t get any pedal...
I’ve got a 08 Tahoe 4x4 and there is a squeaking coming from the drivers side front wheel. I put new rotors and brakes on about a 2 months ago. About a month after I started getting a squeaking in the wheel, it does it mostly at lower to mid speeds, if you barely touch the brake pedal it goes...
I had autozone test my battery and alternator about a month ago, they both checked out good. I will have it rechecked to be sure. Does anyone have a good picture diagram of all the ground wires and where there located so I can make sure I check them all?
I’m new to the forum, and have a few questions about my Tahoe. I have 08 Tahoe 4x4 lt, with 82,000 Miles. I am having some electrical issues.
Yesterday when I started it and started driving and noticed the speedometer wasn’t working or any of the gauges. So I pulled over and shut it off...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.